Yamaha NX-S100S Owner's Manual download pdf (Page 61)

Setting the manufacturer code (remote control signal

assigned to each manufactm'er) for your TV, VCR or MD/

CD recorder on the remote control allows you to operate

not only the DVX-S 100 but also your TV, VCR or MD/

CD recorder using the remote control.

• Depending on the model, certain components fi'om o_her

manufacture_ cannot be controlled, or only limited functions

can be controlled, even though the proper manufacturer code

has been set, If you encounter this problem, please use the

remote control supplied with the component.

Manufacturer codes can be set for TV, VCR and MD/

CD-R buttons only.

• TV manufacturer codes can be set }k_rthe TV button only.

However, any of the manufacturer codes can be set tk)r the VCR

and MD/CD-R buttons.

Numeric buttons

(U.S.A. model)

[] While pressing CODE SET, press the input

selector button (TV, VCR, MD/CD-R) for which

the manufacturer code is to be set.

Only one manufacturer code can be set for each input

selector button.

Keep pressing CODE SET between step 1 and 2.

• Refer m "LIST OF MANUFACTURER'S

CODES" at the end of this manual.

[] Keeping CODE SET pressed, enter the t-

digit device code and the 2-digit

manufacturer code for the component to be

controlled using the numeric buttons.

You can release CODE SET after entering the code.

.,+,:

• The manufacturer code 99 has been set _._rthe remote control

selector buttons (TV, VCR and MD/CD-R) at the factory.

I_J Press POWER (TV or AV) and check that the

component to be controlled turns on and off

(standby),

Precautions when performing the setting

You can operate the component using the "IV, VCR or

MD/CD=R operation buttons on the remote control once

the manufacturer code is set properly. If unsuccessful,

perform the procedure from step 1 again. Pay attention to

the following points when you perform the procedure.

• Check that the con'ect remote control selector button

has been selected when setting the manufacturer code.

• If more than one code is given for a manufacturer, try

entering each code in the order given.

• Remove and replace the remote control's batteries

(complele this step within 2 minutes) and then perform

the procedure. While replacing the batteries, be sure not

Io press any button on the remote control. Doing so

may erase the manufacturer code which has been set

for other remote control selector buttons.

To reset the manufacturer code to the

factory-set code

Follow steps 1 to 2 for the procedure "Setting the

manufacturer code", and enter the device code for the

component and "99" while pressing CODE SET in step 2.

(It is not necessary to follow slep 3.)

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 81 82

Comments to this Manuals

No comments

Yamaha NX-S100S Owner's Manual Page 61

Comments to this Manuals

Related products and manuals for Receiver Yamaha NX-S100S