g_lehq_q_ft,ll#[Oh_l"
I Connector
Color lube
(RED)
(BLUE)
Conllector
(BLUE)
Color tube
(BLUE)
• The connector of the included speaker cable and the terminal of
the subwoof_r are classified by color. Connect the same colors.
• The label of the speaker is attached to each speaker cable.
Connect the speakers in accordance with the labels.
• Connect the color tube of the speaker cable to the plus (+) side
of each speaker. If the polarity of the speaker connections is
incorrect, the sound will be unnatural and lack bass.
• A cover is attached to the end of the speaker cable. Connect the
speakers after removing the cover.
• Make sure that the plugs of the system connector cable and the
connectors of the speaker cables al_e inserted correctly betbre
inserting them.
• Do not let the bare speaker wires touch each other or any metal
part of this unit. This could damage this unit and/or the
speakers.
• Do not insert the plug or conneclor fk_rcibly. Doing so may
damage the plug, connector or _erminah
• Do not scralch, _rcibly bend, or pull the system connector or
speaker cable as this may damage the cable, causing loss of
audio oulput, and may possibly result in a fire or electric shock.
Take particular care in making sure that the cable is not
squashed by a rack or caster.
• Be_k_re disconnecting or connecting _he system connector
cable, disconnect the power supply cord of the subwoofer and
DVD audio/video receiver.
• Using commercially available
speakers and speaker cables
You can use commercially available speaker cables and
speakers excepl for a subwoofer. If you use them, hole the
following.
• Use the speaker whose impedance is 6£2 or higher.
When using Ihe speaker whose impedance is lower than
6£2, the protection circuit may start working or this unit
may be damaged.
• Use magnetically shielded speakers. If this type of
speakers still creates the interference with the monitor,
place the speakers away from the monitor.
• Use the speaker cable that is as thick as the included
cable. "Ibo thick cables cannot be used.
Exchanging the speaker cables
O Tab
_1 Remove approximately 15 mm (9/16") of
insulation from each of the speaker cables.
Twist the exposed wires of the cable together to
prevent short circuits.
[] Open the tab.
I_] Pull the inserted bare wire of the speaker
cable from the connector and insert the bare
wire of the commercially available speaker
cable,
[] Return the tab to secure the wire,
18
Comments to this Manuals