Yamaha NX-S100S Owner's Manual download pdf (Page 72)

jl;{e]lJ;te,,*_;[_ie_ll_T[.

Problem Cause

No sound from the

center speaker.

No sound from the

rear speakers.

No sound from the

subwoofer.

Poor bass

reproduction.

A "humming" sound

can be heard.

The volume level

cannot be increased,

or the sound is

distorted.

The sound effect

cannot be recorded.

A source cannot be

recorded by a digital

recording

component

connected to the

DIGITAL OUTPUT

jack of this unit.

This unit does not

operate properly.

The output level of the center speaker is set to

rrfinimum.

"IA CENTER" on the SET MENU isset to

NON.

One of the Hi-Fi DSP programs (1 to 4) has

been selected (except for 5ch Stereo).

The source encoded with a Dolby Digital or

DTS signal does not have a center channel

signal.

The output level of the rear speakers is set to

minimmn.

A monam'al som'ce is being played with

program 9.

"ID BASS" on the SET MENU is set to

FRONT when a Dolby Digital or DTS signal

is being played.

"ID BASS" on the SET MENU is set to

SWFR or FRONT when a 2-channel som'ce is

being played.

The source does not contain low bass signals

(90 Hz and below).

The speaker mode settings (front, center, or

rear) on the SET MENU do not match your

speaker contiguradon.

[nCOlTeC[ cable connections.

The component connected to the OUT (Rec)

jacks of this unit is turned oil

It is not possible to record the sound effect by

a recording component.

A source component is not connected to the

DIGITAL INPUT jacks of this unit.

Remedy

Rals_ the level of the center speaker.

Select the appropriate mode for your cemer

speaker.

Select another DSP prograin.

Rals_ the output level of the rear speakers.

Select another DSP prograin.

Select SWFR or BOTH.

Select BOTH.

Refer

to page

23-24

23 - 24

Select the appropriate position for each speaker 60 - 61

ha.ted on the size oftbe speakers in your

contiguration.

Firmly connect the audio plugs. If the problem 14 - 15

persists, the cables may be defective.

Turn on the power to the component.

Connect the source component to the DIGITAL

INPUT jacks of this unit.

The internal microcoinputer has been frozen Disconnect the AC power cord from the outlet --

by an external electric shock (such as and then plug it in again after about 30 seconds.

lightning or excessive static electricity) or by

a power supply with low voltage.

There is noise This unit is too clos_ to the digital or high- Move this unit further away from such --

interference from ti'equency equipment, equipment.

digital or high*

frequency equipment,

or this unit.

14 - 15

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 81 82

Comments to this Manuals

No comments

Yamaha NX-S100S Owner's Manual Page 72

Comments to this Manuals

Related products and manuals for Receiver Yamaha NX-S100S