Yamaha MO6 Owner's Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 240
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
Power supply
21
Owner’s Manual
Setting up
and Playing
Turning the power on
Make sure the volume settings of the MO and external devices are turned down to the minimum.
Turn the power on by pressing the [STANDBY/ON] switch on the MO rear panel, then turn the power on the
amplifiers.
Adjusting the sound and the display contrast
Adjust the volume levels of the MO and the connected amplifier/speaker system. If the display is not easily
visible, use the Contrast control to adjust for optimum visibility.
Connecting MIDI devices or a Mixer
Make sure that all volume settings are turned down all the way to the minimum. Then turn on the every
device in your setup in the order of MIDI masters (controllers), MIDI slaves (receivers), then audio
equipment (mixers, amplifiers, speakers, etc.).
When powering down the setup, first turn down the volume of each audio device, then switch off each
device in the reverse order (first audio devices, then MIDI).
Now that you’ve set up the MO properly, you’re ready to begin playing it.
n When you are ready to turn off the MO, make sure to switch off the power of the external device (or lower its volume)
before switching off the MO.
MASTER
VOLUME
POWER
ON!!
1 2 3
MIDI master MO (MIDI slave) Audio equipment
(first mixer, then amplifier)
F1
SF1
MASTER
VOLUME
Adjust the volume with the
MASTER VOLUME slider.
Contrast control
Adjust the display contrast
with the Contrast control.
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 239 240

Comments to this Manuals

No comments