Yamaha DTXPLORER Specifications download pdf (Page 12)

Now that your DTXPLORER is properly connected, it’s time to make some music!

Time to Play

CAUTION

To avoid damage to your speakers, first switch the

DTXPLORER’s power ON then switch on Audio De-

vices and the Mixer or Amplifier.

KIT1 _________

1 :Acoustic ‚

1. Switch the power ON

After confirming that all devices, pads, external devices, etc.,

are properly connected, press the POWER switch located on

the rear panel to switch the power ON.

After purchasing the DTXPLORER, the following message

will appear in the display the first time you switch the power

on.

After hitting a pad several times, switch the power off and then

on again, and the total number times the pads have been hit is

shown in the display (Hit Counter Function).

* The Hit Counter is reset to “0” after carrying out the factory

set. (P. 23)

When the Drum Kit Select display (shown below) appears, the

DTXPLORER is ready to be played.

* The most recently used drum kit is selected in the display.

* Press the [DRUM KIT] button if another display is shown.

2. Play the DTXPLORER

While hitting on the pads, rotate the volume knob on the rear

panel to the right to increase the overall volume to a comfort-

able volume level.

Rotating the knob to the right increases the volume level while

rotating to the left decreases.

3. Select A Drum Kit

Each kit is made up of voices that are produced when a pad is

hit. Drum kit numbers 1 through 32 consist of 32 different types

of preset drum kits that have been specially programmed by

Yamaha sound designers.

Rotate the jog dial to select a drum kit.

Try out some of the different drum kits and select a kit you’d

like to use.

4. Change the Output Sound Quality

Use the [Master Equalizer] display found on page 4 in the Utility

Mode to change the output sound quality. Overall settings for

the DTXPLORER are set in the Utility Mode.

First, press the [SHIFT] + [SAVE/ENT] buttons to enter page

1 in the Utility Mode.

The “HHofs=” value is flashing. Press the [>] button once to

move the flashing cursor to the “T=” value position.

Press the [>] button again to go to page 2 in the Utility Mode.

The “OutSel=” value is flashing.

Press the [>] button twice to go to page 4 in the Utility Mode.

Drum Kit Name

KIT1 _________

1 :Acoustic ‚

Drum Kit Number

Drum Kit NameDrum Kit Number

UTIL1 Hi-hat

HHofs= 0 T= 0‚

UTIL1 Hi-hat

HHofs= 0 T= 0‚

* DTXPLORER *

* Welcome! *

* DTXPLORER *

* 5hits *

Page 1 of the Utility Mode

UTIL2 Click

–OutSel=mix ‚

UTIL4 MasterEQ

–Lo=+ 4 Hi=+ 8 ‚

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Comments to this Manuals

No comments

Yamaha DTXPLORER Specifications Page 12

Comments to this Manuals

Related products and manuals for Music drums Yamaha DTXPLORER