Yamaha DTXPLORER Specifications download pdf (Page 16)

Play Along With The Metronome

8. Save an Original Click Set

After creating your own original click set, save it in the

DTXPLORER’s memory using the Store Operation de-

scribed below.

*Any changes made to the data will be lost if another click set

is selected before carrying out the store operation.

8-1. Press the [SAVE/ENT] button. The following display will

appear.

8-2. Rotate the jog dial to select the destination memory num-

ber (1 to 30) that you want to store the click set in.

8-3. Press the [SAVE/ENT] button again and the following

display asking your confirmation to proceed with the store

operation.

8-4. Press the [SAVE/ENT] button to carry out the store op-

eration.

*To cancel the store operation, press any button except

for the [SAVE/ENT] and [SHIFT] buttons (when “Are you

sure?” appears in the display, the jog dial will also can-

cel the operation).

The following display appears after the store operation is

complete.

CLK save to 1

Are you sure ?

Completed!

Store

Destination

You can use the “Factory Set” operation to reset the

contents of click sets 1 through 30 to their original

factory condition.

However, please proceed with caution because carry-

ing out this operation will rewrite the DTXPLORER’s

entire contents (all click sets, user trigger setup (No.

5), user drum kits 33 to 42) with the data that was set

in the unit’s memory when it was shipped from the

factory. (P. 23)

Click Out Select

The DTXPLORER lets you select from which output jack

the metronome’s signal is delivered. Click output and per-

formance output can be routed to separate outputs.

Procedure

Press the [SHIFT] + [SAVE/ENT] buttons and the

following display will appear. (Page 1 in the Utility

Mode.)

Next, press the [>] button twice so that the follow-

ing display appears.

Rotate the jog dial to select the output from the out-

puts listed below.

mix: This is the standard output setting. The

click signal is delivered from both the OUT-

PUT L and R jacks.

clickL: The click signal is delivered from the OUT-

PUT L jack only. All drum performance and

song playback is delivered in monaural via

the OUTPUT R jack.

clickR: The click signal is delivered from the OUT-

PUT R jack only. All drum performance and

song playback is delivered in monaural via

the OUTPUT L jack.

* The PHONES jack delivers the same signal as the

OUTPUT jacks. The settings in this section would then

be applied to the PHONES jack’s stereo L and R.

UTIL1 Hi-hat

HHofs= 0 T= 0‚

UTIL2 Click

–OutSel=mix ‚

CLK save to 1

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Yamaha DTXPLORER Specifications Page 16

Comments to this Manuals

Related products and manuals for Music drums Yamaha DTXPLORER