Yamaha DTXPLORER Specifications download pdf (Page 9)

Connections

Connecting the DTXPLORER’s pads to the main unit

Refer to the illustration below and connect each pad’s output cable to each Trigger Input jack on the rear panel of the DTXPLORER.

All Trigger Input Jacks are labeled (1 SNARE, etc.) so make sure each pad is connected to its corresponding Trigger Input jack.

*The DTXPLORER’s settings will provide optimum performance when pads (1 SNARE, etc.) are connected to their corresponding Trigger

Input jacks, however, if other pads or drum triggers that have different operating characteristics are connected to the jacks, settings for

sensitivity, etc., as described in the “Trigger Setup Edit” section (P. 24) should be changed.

CAUTION

To prevent electric shock and damage to the devices, make sure the power is switched OFF on the

DTXPLORER and all related devices before making any connections to the DTXPLORER’s input and

output jacks.

The DTXPLORER can be played from an acoustic drum kit if the kit is fitted with an optional set of Yamaha DX20 Drum Triggers and the

triggers are connected to the DTXPLORER’s input jacks.

* After making connections, make sure settings in the DTXPLORER’s trigger setup (P. 24) are properly adjusted.

Using the DTXPLORER with an Acoustic Drum Kit

to 8 KICK/9

to 1 SNARE

to 2 TOM1

to 3 TOM2

to 4 TOM3

to 5 RIDE

to 6 CRASH

to 7 HI HAT

to HI HAT

CONTROL

* The kit can be expanded with an

optional monaural pad (PCY65, etc.)

connected to the external pad input

jack on the KP65.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

No comments

Yamaha DTXPLORER Specifications Page 9