Yamaha RX-V3900 Owner's Manual download pdf (Page 39)

35 En

Optimizing the speaker setting for your listening room

PREPARATION

English

The results of the measurement that are the causes of the

warning message(s) appear in yellow or pink.

• “–––” appears when no speaker is connected to the

corresponding speaker channel or this unit does not measure the

corresponding speaker channel yet.

• If you change speakers, speaker positions, or the layout of your

listening environment, run the automatic setup again to

recalibrate your system.

• The distances displayed in the “Distance” results may be longer

than the actual distance depending on the characteristics of your

subwoofer or external amplifiers if you connect them.

• In the “Equalizing” results, different values may be set for the

same band to provide finer adjustments.

6 To reload the displayed parameter, press

9ENTER.

7 Press IMENU to turn off the GUI menu.

• You can also set the parametric equalizer type with “PEQ

Select” (page 91).

• You can set the phase of the connected subwoofer with “Phase”

(page 88).

Parameter Descriptions

Multi Measure

(Multiple point

measurement)

Displays the number of listening position

actually measured.

Wiring

(Speaker wiring)

Displays the polarity of each connected

speaker.

– “NRM” appears when the polarity of the

connected speaker is normal.

– “REV” appears when the polarity of the

connected speaker is reversed.

– “DET” appears when this unit detects the

subwoofer is connected.

– “–––” appears when no speaker is

connected to the corresponding speaker

channel.

Distance

(Speaker

distance)

Displays the speaker distance from the

listening position. Press 9h repeatedly to

switch the unit to display the value of the

each speaker distance.

Size

(Speaker size)

Displays the size of the connected speakers

and the bass cross over frequency (“Cross”).

– “LRG” appears when the connected

speaker has the ability to reproduce the

low-frequency signals effectively.

– “SML” appears when the connected

speaker does not have the ability to

reproduce the low-frequency signals

effectively.

Equalizing

(Speaker

equalizing)

Displays the result of the adjustment of the

frequency responses of each connected

speaker. You can switch the parametric

equalizer type that appears in the result

display by pressing 9h repeatedly in the

“Equalizing” result display. To apply the

result that is displayed in the display, press

9ENTER.

Choices: Natural, Flat, Front

– Select “Natural” to average out the

frequency response of all speakers with

higher frequencies being less

emphasized. Recommended if the “Flat”

setting sounds a little harsh.

– Select “Flat” to average the frequency

response of all speakers. Recommended

if all of your speakers are of similar

quality.

– Select “Front” to adjust the frequency

response of each speaker in accordance

with the sound of your front speakers.

Recommended if your front speakers are

of much higher quality than your other

speakers.

Level

(Speaker level)

Displays the result of the adjustment of each

connected speaker output level. You can

display the result of the adjustment of the

speaker level for each parametric equalizer

type (see above) by pressing 9h

repeatedly. Select “Through” to display the

result when this unit does not use the

parametric equalizer.

Notes

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 322 323

Comments to this Manuals

No comments

Yamaha RX-V3900 Owner's Manual Page 39

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V3900