Yamaha RX-V3900 Owner's Manual Page 136

  • Download
  • Add to my manuals
  • Print
  • Page
    / 323
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 135
132 En
Troubleshooting
Remote control
Problem Cause Remedy
See
page
The remote control
does not work or
function properly.
Wrong distance or angle. The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
28
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition this unit.
The batteries are weak. Replace all batteries.
4
The batteries do not last long and get
quickly exhausted.
Using alkaline batteries is strongly recommended.
Set the backlight mode to “OFF”.
109
The operation mode selector is set
incorrectly.
Set the operation mode selector correctly. When
operating this unit, set it to the
F
AMP position.
When operating the component selected by the input
selector button, set it to the
F
SOURCE position.
When operating the TV set in the
3
TV area, set it to
the
F
TV position.
The control zone setting is incorrect. Select the zone you want to control.
119
The remote control code is not correctly
set.
Set the remote control code correctly using
“List of remote control codes” at the end of this
manual.
109
Try setting another code of the same manufacturer
using “List of remote control codes” at the end of this
manual.
109
The remote control ID of the remote
control and this unit do not match.
Match the remote control ID of this unit and the
remote control.
116, 121
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
Program the necessary functions independently into
the programmable buttons using the Learn feature.
111
The remote control
does not learn new
functions.
The batteries of this remote control and/or
the other remote control are too weak.
Replace the batteries.
4
The distance between the two remote
controls is too much or too little.
Place the remote controls at the proper distance.
111
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Learning is not possible.
Memory capacity is full. Delete other unnecessary functions to make room for
the new functions.
115
Page view 135
1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 322 323

Comments to this Manuals

No comments