Yamaha RX-V3900 Owner's Manual download pdf (Page 35)

31 En

Optimizing the speaker setting for your listening room

PREPARATION

English

It is recommended that you use a tripod (etc.) to affix the

optimizer microphone at the same height as your ears

would be when you are seated in your listening position.

You can use the attached screw of a tripod (etc.) to fix the

optimizer microphone to the tripod (etc.).

3 Press 9ENTER to start the measurement.

This unit starts to count down from 10 seconds.

• To start the measurement immediately, press 9ENTER

again.

• To cancel the automatic setup and return to the previous

screen, press 0RETURN.

Loud test tones are output from each speaker during

the measurement. Once all items are measured,

“COMPLETED” appears.

If an error or warning message appears, see “Automatic

setup” (page 136).

4 Disconnect the optimizer microphone to

complete the automatic setup.

You can check the results of the measurements by using

the GUI screen (page 34).

Use this feature to optimize the setup of this unit this unit

for one listening position. You can also select the

parameters to be optimized in the automatic setup.

1 Turn on the video monitor and then follow

steps 1 and 2 in “Quick automatic setup”

(page 30).

2 Press IMENU on the remote control.

The following screen (GUI menu) appears in the

video monitor.

3 To select the parameters to be optimized,

press 9k to select “Setup Menu” and then

press 9h.

When you do not need to select the parameters to be

optimized, skip to step 6.

If you do not select the parameters to be optimized, this

unit will optimize the parameters you selected last time.

All the parameters are selected by the initial factory

settings.

4 Press 9k / n repeatedly to select the

parameter and then press 9ENTER to

check or uncheck the box.

Check the boxes for the parameters to be optimized.

Before proceeding next operation

Once you perform the next operation, this unit starts the

automatic setup procedure in 10 seconds. During the

automatic setup procedure, do not perform any operation on

this unit. For more accurate measurements, we recommended

that you get out of the room or move to the wall where

speakers are not around during the measurement. It takes

approximately 3 minutes.

Note

Optimizer microphone

COMPLETED

PLS UNPLUG MIC

ERROR: E-01

PRESS ENTER

Basic automatic setup

Parameter Descriptions

Multi Measure

(Multiple point

measurement)

You can optimize the setup of this unit for

multiple listening positions. For details, see

“Advanced automatic setup” (page 33). In

the basic automatic setup, leave this setting

to the default.

Wiring

(Speaker wiring)

This unit checks and adjusts which speakers

are connected and the polarity of each

speaker.

Information

Setup Menu

Start

NOTICE

Loud test tones are

output.

Please keep quiet

or leave the room.

Start:ENTER

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 322 323

Comments to this Manuals

No comments

Yamaha RX-V3900 Owner's Manual Page 35

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V3900