Yamaha RX-V3900 Owner's Manual download pdf (Page 116)

112 En

Remote control features

7 Press

SETUP again to exit from the setup

menu.

• “ERROR” appears in the display window (4) on the remote

control if you press a button not indicated in the respective step,

or when you press more than one button simultaneously.

• This remote control can learn approximately 200 functions.

However, depending on the signals learned, “FULL” may

appear in the display before you program 200 functions. In this

case, clear unnecessary programmed functions to make room

for further learning (page 115).

• Learning may not be possible in the following cases:

– when the batteries in the remote control for this unit or other

components are weak.

– when the remote control is exposed to direct sunlight.

– when the function to be programmed is continuous or

uncommon.

You can change the name of the control area (input

source) that appears in the display window (4) on the

remote control.

1 Set the operation mode selector to

FSOURCE and then press an input selector

button (3) to select the desired control area.

2 Press GSETUP using a ballpoint pen or

similar object.

“SETUP” appears in the display window.

3 Press 9k / n repeatedly to select “RNAME”

and then press 9ENTER.

4 Press 9k / n repeatedly to select 3-letter

name or 5-letterd name you want to edit and

then press 9ENTER.

Each control area has both 3-letter name and 5-letter

name. You can rename the 3-letter name and 5-letter

name independently.

5 Edit the name of the control area.

To locate the position to edit , press 9l / h.

To select a character, press 9k / n.

Press 9k to change the character in the following order,

or press 9n to go in the reverse order: A to Z, a to z, 0 to

9, space, symbols (–, +, /, :).

6 Press 9ENTER to set the new name.

“OK” appears in the display window (4) on the

remote control if renaming was successful.

When you want to rename the another control area, press

the input selector button (3) or 5SELECT l / h

repeatedly to select the desired control area and then press

9ENTER and then carry out the operations of steps 4

through 6.

7 Press

SETUP again to exit from the setup

menu.

“ERROR” appears in the display window (4) on the remote

control if you press a button not indicated in the respective step,

or when you press more than one button simultaneously.

Notes

Changing source names in the

display window

BD BD/HD

3-letter name 5-letter name

Note

BD/HD

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 322 323

Comments to this Manuals

No comments

Yamaha RX-V3900 Owner's Manual Page 116

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V3900