Yamaha RST90K Owner's Manual download pdf (Page 89)

9-2

2. Open the shroud.

3. Remove the red (+) lead from the lead

holder and move it away from the black

(-) lead.

CAUTION

:

@

Be sure to connect the red (+) jumper

cable to the red (+) lead and the black (-)

jumper cable to the black (-) lead. Do

not reverse the connections.

@

4. Pull the red (+) lead cover to expose

the terminal through the slit in the

cover, and then connect the red (+)

jumper cable to the red terminal of the

discharged battery.

5. Connect the other end of the red (+)

jumper cable to the positive (+) terminal

of the booster battery.

6. Connect the black (-) jumper cable to

the negative (-) terminal of the booster

battery.

7. Pull the black (-) lead cover to expose

the terminal through the slit in the

cover, and then connect the black (-)

jumper cable to the black terminal of

the discharged battery.

8. Start the engine.

9. Disconnect the black (-) jumper cable

from the black (-) connecting lead, and

then pull the cover completely over the

lead terminal.

10. Disconnect the black (-) jumper cable

from the negative (-) terminal of the

booster battery.

11. Disconnect the red (+) jumper cable

from the positive (+) terminal of the

booster battery.

12. Disconnect the red (+) jumper cable

from the red (+) connecting lead, and

then pull the cover completely over the

lead terminal.

13. Install the red (+) lead into the lead

holder.

U8ET10.book Page 2 Monday, June 14, 2004 5:42 PM

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 98 99

Comments to this Manuals

No comments