8-23
ESU04220
Control rod adjustment
The weight transfer can be adjusted by turning the con-
trol rod adjusting nut
1
.
1. Loosen the locknut
2
while holding the control rod
adjusting nut.
2. Turn the adjusting nut in direction
a
to increase
weight transfer or direction
b
to decrease weight
transfer.
3. Tighten the locknut while holding the adjusting nut in
place.
CAUTION
:
@
●
When using the two wrenches included in the
owner’s tool kit, make sure that they are situated
at a right angle to the control rod as shown, and
that they are tightly fitted to the locknut and the
control rod adjusting nut.
●
The left and right adjusting nuts must be set to
the same position. Uneven settings can cause
poor handling and loss of stability.
@
WARNING
@
Never adjust the control rods beyond the maximum
range indicated on the rods with red paint 3.
@
c
Adjustable range
d
Standard position
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lb)
U8ET10.book Page 23 Monday, June 14, 2004 5:42 PM
Comments to this Manuals