Yamaha YZF-R1 Service Manual download pdf (Page 156)

100

101

3 - 61

CHK

ADJ

CHECKING AND CHARGING THE BATTERY

Charging method using a variable-current (voltage) charger

Measure the open-circuit

voltage prior to charging.

Connect a charger and

AMP meter to the battery

and start charging.

Make sure that the current

is higher than the standard

charging current written on

the battery.

YES

Charger

AMP meter

Adjust the voltage so that the

current is at the standard charg-

ing level.

Set the time according to the

charging time suitable for the

open-circuit voltage.

Refer to “Battery condition

checking steps”.

By turning the charging voltage

adjust dial, set the charging at

20 ~ 24 V.

Monitor the amperage for 3 ~ 5

minutes to check if the standard

charging current is reached.

YES

If the current does not exceed

the standard charging current

after 5 minutes, replace the bat-

tery.

If charging requires more than 5 hours, it is advisable to check the charging

current after a lapse of 5 hours. If there is any change in the amperage,

readjust the voltage to obtain the standard charging current.

Measure the battery open-circuit voltage after leaving the battery unused

for more than 30 minutes.

12.8 V or more --- Charging is complete.

12.7 V or less --- Recharging is required.

Under 12.0 V --- Replace the battery.

Voltage should be measured 30

minutes after the machine is

stopped.

Set the charging voltage at

16 ~ 17 V. (If the setting

lower, charging will be insuffi-

cient. If too high, the battery

will be over-charged.

NOTE:

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 438 439

Comments to this Manuals

No comments

Yamaha YZF-R1 Service Manual Page 156

Comments to this Manuals

Related products and manuals for Toys & accessories Yamaha YZF-R1