Yamaha BWS CW50L Service Manual Page 77

  • Download
  • Add to my manuals
  • Print
  • Page
    / 107
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 76
Ic.As IE-lel STEE.,.O.EAOA.O...OLE ..
10. Remove: JA **......... ******************************************
Securing nut Bearing race replacement steps:
Ring nut 0 Drive out the bearing race from the steering
Washer tube by hitting on it in several places.
Remove the bearing race on the steering
NOTE: shaft with a hammer and a chisel Q as
Use the Ring Nut Wrench (_) to loosen the ring shown.
nut. Drive in the new bearing races evenly by
I<_ Ring Nutwrench:90890-01268 I .... hitting on them in several places.
Support the front fork so that it may not fall down. _ CAUTION;;
Unless the ball race is installed evently, it
Washer (_) will damage the frame or steering column.
Upper bearing race (_ Do not hit the face of the ball race.
'X_ Steering shaft .....................................................
Bearing balls
I
NOTE:
Take care not to loose the bearing balls. (Upper: _0o8
22 pieces, Lower: 22 pieces).
INSPECTION _ 4. Check:
1. Check: Steering shaft
Handlebar O _ Bend/Damage --* Replace.
Bends/Cracks/Damage _ Replace. VTI_?7_[E_Tr_
Never attempt to straighten a bent steering
2. Wash the bearing balls in solvent, shaft.
354OO9
3. Check: ASSEMBLY AND INSTALLATION
Bearing races (_ Reverse the"REMOVAL" and "DISASSEMBLY"
_ _(_ Pitting/Damage -.*Replace. procedure.
Bearing balls (_ Note the following points.
Pitting/Damage --*Replace. V.I_i_--'_,I]]]_
C) NOTE: Proper cable and hose routing is essential to
Always replace the bearing balls and the upper insure safe scooter operation. Refer to
and lower bearing races as a set. "CABLE ROUTING" in CHAPTER 2.
Bearingsize: 1
Upper: 3/16 in _.,D_, 1. Install:
Lower: 3116in JIL_J=m Bearing balls
I Bearing quantity:
Upper: 22 pcs 3_ 2. Apply:
Lower: 22 pcs Wheel bearing grease (to upper and lower
bearing).
olo
6-25 6-26
Page view 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 106 107

Comments to this Manuals

No comments