_.O..E,SSE.LYA.O,O,OST.E.T_ 0-21 E"O'"EASS_--_'"O,O,0ST.E.TIE"O_ I
TRANSMISSION STARTERSYSTEM
1. Apply: (_ Collar _ Plate
• 10W30 Type SE Motor oil (_ Washer _ Shaft
(to transmission case cover bearing) _ Bearing _ Plain washer
_) Starter wheel gear _ Idle gear
2. Install: _ Collar @ O-ring
• BearingC) _ Starterclutch @Startermotor
3. Install:
_C_, 1 j_/_ • 0,, seal (_) f-
• Secondary sheave axle (_) _-
,' _ _l NOTE:.
Apply lithium soap base grease onto the oil seal
lips.
319O14 i
4. Check:
• Secondary sheave axle operation ./.
Unsmooth operation _ Repair. _ ¢
5. Apply: - !
• 10W30 type SE Motor oil
(to main axle bearing and drive axle bearing)
6. Install: / _ ,/_
._-__ *Drive axle C)
: • Main axle (_
• Conical spring washer (_) 113 Nm (1.3 m.kg, 9.4 ft.lb)l
--;'P"'n--°
- Apply lithium soap base grease onto the oil seal (_b L
lips. _ ii
s19o16 • Always use a new gasket.
(_).__(_. 7. Install: 4 -I 8 Nm (0"8 m'kg' 5"8 ft"
_.__._:2) • Gasket (_)
" • Dowel pins
• Transmission case cover O
_ I_lso_,°..e°o.., I
__._----_ 12 Nm (1.2 m.kg, 8.7 ft.lb) _'L_i-}
4 - 27 4 - 28
Comments to this Manuals