Yamaha BWS CW50L Service Manual download pdf (Page 67)

MASTER CYLINDER DISASSEMBLY _'!!w-'_;l_ _[dl

Master cylinder Q Bolt NOTE: • Disc brake components rarely require dis-

® Master cylinder piston ass'y _ Brake hose Drain completely before removing the master assembly. Do not disassemble components

Diaphragm _ Bolt cylinder, unless absolutely necessary. If any hydrau-

Master cylinder cap @ Bolt lic connection is disconnected, the entire

Screw _ Copper washer system must be disassembled, drained,

Master cylinder bracket cleaned, and then properly filled and bled

after reassembly. Do not use solvents on

internal brake component.

• Solvents will cause seals to swell and dis-

I1.5 Nm (0.15 m.kg, l.lft.lb) _ tort. Use only clean brake fluid for cleaning.

..... ____ Use care with brake fluid. Never allow brake

fluidtocomeincontactwith eyes.

the

Brake

_ _tl 110.8Nm (1.08m./kg, 8 ft.lb)] ticfluid can damage painted suparts, rfaces and plas-

BRAKEPADREPLACEMENT

/ It is not necessary to disassemble the brake

L... caliper and brake hose to replace the brake

pads.

1. Remove:

• Pin (D

BRAKE FLUID _ \ • Axle _)

} "

DOT# 3 or DOT# 4 ',, ._ _:.. 2. Remove:

_ Nm(2.3m.kg,17ft.lb)] •Padspring(_)

oBrake pads (_)

NOTE:

Replace the brake pads as a set when either one

is worn to the limit.

__ 3, Measure:

oBrake pads

Out of specification -_ Replace.

NOTE:

(_) Replace the brake pad and spring as a set when

(2.3 m.kg, 17ft.lb)l _X,

replacing the brake pads.

_ Fr°ntBrakePadsWearLimit@: I

3,7007 0.8 mm (0.03 in)

6-5 6-6

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 106 107

No comments

Yamaha BWS CW50L Service Manual Page 67