E"O'"E'SSE"B,.O,O,OSTME.TIE"O 10"8 E"O'"E'SSE B ,.O,O,OSTME.T
8. Install: =j _, 5. Tighten:
• Air shroud _ • Rear wheel axle nut (T)
• Oil hose
• Oil delivery hose NOTE:.
When tightening the rear wheel axle nut, apply
NOTE: the rear brake.
Pass the oil delivery hoseand oil hose asshown. Rear103.5wheelNmaxle(10.35nUt:m.kg,74.8 ft.lb) I
9. Air bleeding: ___._ 6. Install:
• Autolube pump __ • ProtectorMuffler assembly
Refer to "AUTOLUBE PUMP AIR BLEEDING" • Muffler assembly 0
in CHAPTER 3. (_) • Air shroud (_).
29 Nm (2.9 m.kg, 21.0 ft.lb)
Bolt (exhaust pipe):
6.5 Nm (0.85 m.kg, 6.15 ft.lb)
7. Fill:
____ ENGINE REMOUNTING • Transmission oil
Reverse the removal procedure. Refer to "TRANSMISSION OIL REPLACE-
Note the following points. MENT" in CHAPTER 3.
1, Install: 8. Adjust:
• Engine mounting bolt 0 • Brake lever free play
• Rear shock absorber bolt (_)(lower) Refer to "FRONT/REAR BRAKE LEVER FREE
Theseboltsshouldbetemporarilysecured. PLAYADJUSTMENT"in CHAPTER3.
2. Tighten: • Engine idle speed
• Engine mounting bolt • Throttle cable free play
• Rearshockabsorberbolt(lower) Referto"THROTTLECABLEFREEPLAYAD-
I'll I' ,usTNTan,,OL
\ _ Engine mounting bolt: JUSTMENT" in CHAPTER 3.
42 Nm (4.2 m.kg, 30.4 ft.lb)
/ Rear shock absorber bolt (lower):
17.5 Nm (1.75 m.kg, 12.6 ft.lb)
3. Install:
• Carburetor top togetherwith throttle valve0
oFuel hose (_)Nacuum hose (_)
• Rear brake cable
NOTE:
_ _ When installing the throttle valve into the
carburetor, align the groove of the throttle valve
with the projection of the carburetor.
4. Connect:
• Spark plug cap (D
• Starter motor (_
\ .CDI magneto lead ®
• Earth (ground lead)
4-39 4-40
Comments to this Manuals