TIRE INSPECTION/WHEEL INSPECTION/ I INSP I I I CABLE INSPECTION AND LUBRICATION/ I INSP I
CABLE INSPECTION AND LUBRICATION _ _ B - 15 REAR SHOCK ABSORBER _
esr ivuco
I:_ • Tire tread depth 1. Lubricate rotating parts of the levers
Out of specification ._ Replace.
Recommended lubricant:
I_ Minimum tire tread depth Engine oil SAE 10W30
(_ (front and rear):
I 0.8 mm (0.03 in) CENTERSTAND LUBRICATION
1. Lubricate rotating parts
(D Tread depth
(_) Side wall I_=_ Rec°mmended lubricant: I
® Wear indicator Engine oil SAE 10W30
WHEEL INSPECTION
1. Inspect:
• Wheels
Damage/Bends _ Replace.
Fv_
Never attempt even small repairs tothe wheel.
CABLE INSPECTION AND LUBRICATION F'==_=_ .___ REAR SHOCK ABSORBER
1. Check:
VIIYL, I-'I_II_.[tt • Rear shock absorber (D
A damaged cable sheath will rapidly corrode. Oil leaks/Damage _ Replace.
As a result, the cable cannot move smoothly 2. Check:
inside the sheath. Since this situation is • Tightening torque
dangerous, replace a damaged cable Upper bolt:
immediately. 31.5 Nm (3.t 5 m.kg, 22.8 ft.lb)
Lower bolt:
I
1.
Check:
I 17.5 Nm (1.75 m.kg, 12.6 ff.lb)
• Cable sheath
|
° Cable end
Damage --* Replace.
2. Check:
• Cable movement
Stickness --* Lubricate.
I_ Recommended lubricant:
Engine oil SAE lOW30
NOTE:
_._ Hold the cable end up and pour a few drops ofoil
into the sheath.
,,: 3. Lubricate the throttle cable end and the cable
guide notch onthe throttle grip with grease (D.
I_:_ Recommended lubricant:
Lithium soap based grease
3-17 3-18
Comments to this Manuals