Yamaha CRW4260t-B Technical Information download pdf (Page 77)

● Available at: http://www.digidesign.com/download/ptutil.html

● ATTO ExpressPro-Tools v2.3.2 or higher with Synch Transfer Rate set to 20 (10)

and PCI Burst Rate set to 32 bytes

● ATTO ExpressPro-Tools v2.3.2 supplied on Pro Tools v5.1 or 5.1.1 installation CD-

ROM

● Note: Mac OS 9.2 requires ATTO ExpressPro-Tools v2.7 or higher, available at:

http://www.attotech.com/software/

— OR —

Adaptec Power Domain SCSI HBA cards including:

● 2940UW

● 3940UW

with the following requirements:

● Firmware v4.1

● PowerDomain Control v5.1 with cards set to "Fast-SCSI:10" in the Control Panel

● Current Adaptec drivers are available at:

http://www.adaptec.com/worldwide/support/driverindex.html

● Previous drivers are available at: ftp.adaptec.com/mac/scsi/

MIDI: Both USB and serial MIDI interfaces work effectively with Pro Tools. Digidesign

recommends using a serial MIDI interface, as they offer the tightest possible MIDI timing.

Serial MIDI interfaces require either a Mac serial port or a qualified modem-to-serial port

adapter. Digidesign currently supports the

GeeThree Stealth Port or Griffin gPort installed

in the modem port (thereby not using a PCI slot).

When using the GeeThree products with OS 9.0.4, version 1.0.3 or higher of the Stealth

Port extension is required, available here: http://www.geethree.com/download.html

DSP Farm and SampleCell II Support: The PCI Matchmaker chip on a DSP Farm must

be rev QC or QE (check the end of the line directly below “PCI Matchmaker” on the chip) to

be compatible. Cards with rev Q chips can be upgraded.

d24 Support: Some d24 cards may experience recognition problems in the 400 MHz Blue

& White G3 or G4s with AGP Graphics. If so, please contact your local Digidesign office.

Digidesign Compatibility Documents Index

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 241 242

No comments

Yamaha CRW4260t-B Technical Information Page 77