Yamaha CRW4260t-B Technical Information download pdf (Page 6)

● DSP Farm card (Pro Tools III/Pro Tools|24)

● Digi 001

● Audiomedia III

● Pro Tools III Disk I/O

● Pro Tools Project card

● Project II card

SampleCell II

SampleCell II Card without TDM module

The one exception is the SampleCell II card, although the TDM bus cannot be connected to the

Pro Tools HD card because the SampleCell TDM Module is not compatible with Pro Tools|HD

systems. SampleCell II cards can be utilized in Pro Tools|HD systems using Aux tracks to route

the SampleCell I/O Analog outputs physically between the card and audio peripherals. In

addition, you must install the DigiSystem Init v 5.1.1 in your Extensions folder. (included on the

Pro Tools 5.3 CD) Playback is limited to samples at 44.1 and 48 kHz.

Note: The "Getting Started with Pro Tools|HD" guide (version 5.3) that ships with HD systems

with Pro Tools 5.3 incorrectly states on page 11: "Do not use SampleCell hardware cards in a

Pro Tools|HD system. Doing so can result in system crashes. Instead, please use Soft

SampleCell which has been specifically engineered to support 24-bit depths and higher sampling

rates." Although we do recommend using Soft SampleCell with HD systems, you can use

SampleCell II cards as stated above. This information will be corrected in the next document

revision.

Incompatibility with older SampleCell II Cards

A rev "QC" or later of the AMCC chip is required for Blue & White G3 and G4 compatibility. This

rev number appears on the AMCC chip following number "5933". Older versions can cause your

computer to hang while booting or when launching Pro Tools or DigiTest. QC or higher chip is

required for compatibility with the PCI 2.1 spec. Ways to identify these boards are in the grid

below:

Board S/N's Below Manufactured Before Board Rev Before

DSP Farm I FF09226 7/9/97 Rev H

SampleCell II HH02001 5/20/97 Rev D

If a customer has previously updated their board (or received a refurbished card), the serial

number will remain the same, but the board rev will be updated (and the AMCC chip will have

"QC" or later). Cards with the rev "Q" chip can be upgraded. Please contact Digidesign Technical

Support

by phone to arrange for a return authorization. Registration is required.

Note: All SampleCell II Plus cards are newer, and therefore already have the compatible

1 2 3 4 5 6 7 8 9 10 11 ... 241 242

No comments

Yamaha CRW4260t-B Technical Information Page 6