Yamaha LS2000 Operator's Manual download pdf (Page 56)

3-13

OPERATION

STARTING THE ENGINES

SEVERE INJURY OR DEATH MAY

RESULT IF YOU IGNORE ANY OF

THE FOLLOWING:

● Before operating your Jet Boat,

become familiar with all controls.

Consult your Yamaha dealer

about any control or function you

do not fully understand.

● Attach the engine stop switch

lanyard to your personal flotation

device before operating. Failure

to attach lanyard could result in a

runaway boat if operator is

ejected.

● Check throttle, steering and shift

lever for proper operation before

starting the engine.

● Shift into neutral before starting

engines. Put throttle levers in idle

position before shifting.

1) Always make sure the boat is

launched and used in waters that

are free from weeds and debris, and

at least 3 ft (90 cm) deep.

Never operate in water that is less

than 3 ft (90 cm) deep.You increase

your chance of hitting an underwa-

ter obstacle. You could be injured.

Pebbles or sand can also be sucked

into the jet (water) intake, damaging

the impeller.

There is a hull drain plug at the bot-

tom of the stern in the center. Be

sure it is securely tightened before

launching the Jet Boat.

2) Turn the fuel cock knobs to the "ON"

position.

WARNING

CAUTION:

OPERATION 3

WARNING

3 FT (90 CM)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 111 112

Comments to this Manuals

No comments