Yamaha SU700 Owner's Manual download pdf (Page 323)

100

101

APPENDIX

Installing the Options 323

Remove the coverplate.

(Viewing from the rear.)

5. Installing the ASIB1 Board

The optional ASIB1 board (SCSI board) allows the SU700 to connect to external

SCSI storage devices such as hard drives and MO drives so that you can save and

reload large quantities of data quickly and conveniently.

NOTE: The SU700’s factory-default SCSI ID settings are as follows.

•

SU700 SCSI ID: 6

•

External device ID: 5

Preparation

Check that the ASIB1 board has both of its cables attached.

The board should have two bundled cables extending from it, as shown in the illustra-

tion above.

1 Flat cable, extending from rear center.

2 A red/white 2-wire cable.

If you have not yet done so, unfasten and lift off the top cover as described in “Flip-

ping the Cover” on page 314 above. Also be sure that you have a Phillips screwdriver

at hand.

Installation

Remove the two screws holding the small coverplate to the rear panel. Take the

coverplate out.

Keep the two screws handy; you will need them in a minute. You will not need the

coverplate again unless you decide to remove the board.

1 ... 322 323 324 ... 354

Comments to this Manuals

No comments

Yamaha SU700 Owner's Manual Page 323

Comments to this Manuals