Yamaha SU700 Owner's Manual download pdf (Page 308)

Chapter 10 Jobs

308 Chapter 10 Jobs

SU700= 0,...,7 Sets the SCSI ID of the SU700 itself. The factory default is 6. A

change in the setting does not become effective until you restart

the SU700. (If you change the value, the job will offer you the

chance to restart immediately.) This setting is stored in nonvolatile

memory and is not lost at power off.

●

All devices connected to a SCSI chain require IDs. Although the

SU700 ID is not used to support communication directly with

the SU700, it is required to enable other devices on the chain

(computers, samplers, etc.) to communicate with one another.

Procedure

Press SYSTEM | SCSI to enter this job.

NOTE:

This job will execute only if you have installed the optional SCSI board (ASIB1 board) .

▼ The DRIVE= and SU700= settings appear. The DRIVE setting is flashing, indicating

that you can now set this value.

Turn the dial as necessary to set the SCSI ID for the external drive.

Press the button to move to the SU700 setting.

▼ The SU700 settings is now flashing.

Turn the dial as necessary to set the SCSI ID for the SU700.

If necessary, you can move back and forth between the two settings by pressing

and .

Press [OK] or [CANCEL].

▼ A new DRIVE setting becomes effective immediately. If the SU700 setting has not

been changed, the job terminates and the main screen appears.

If you have changed the SU700 setting, the screen displays RESTART? Press [OK]

if you want to restart the SU700 immediately (so that the new SU700 ID setting be-

comes effective immediately.) Press [CANCEL] if you do not wish to restart; in this

case, the SU700 will record the new ID setting, but will not activate it until the next

power-on.

CAUTION

Restarting the SU700 will cause loss of all song data currently stored in the SU700.

1 ... 307 308 309 ... 354

No comments

Yamaha SU700 Owner's Manual Page 308