Yamaha YRS-2100 Manual download pdf (Page 15)

13 En

Initial settings

PREPARATION PLAYBACK SETTINGS

TROUBLESHOOTING

ABOUT THIS UNIT English

CONNECTION/

INITIAL SETTINGS

The screen below is displayed after connecting

IntelliBeam microphone to the unit.

1) 2)

Press ENTER key to start the AUTO

SETUP procedure and then leave the room

within 10 seconds.

The setup screen automatically changes during the AUTO

SETUP procedure.

If AUTO SETUP procedure is complete, this unit rings

the chimes.

AUTO SETUP

(PREPARATION & CHECK)

Please connect the MIC.

Please place the MIC at least

1.8m/6ft away from SoundPro-

jector. The MIC should be set

at ear level when seated.

Measurement takes about 3min.

After [ENTER] is pressed,

please leave the room.

[ENTER]:Start [RETURN]:Cancel

The best setting may not be done if you are in the room. Prepare to

leave the room in 10 seconds after pressing ENTER in step 4.

Note

MEASUREMENT COMPLETE.

BEAM MODE :5Beam/Plus2

SUBWOOFER :Yes

[ENTER]:Save set-up.

[RETURN]:Do

not save

set-up.

XXXXXXXXSHOW RESULTXXXXXXXXXX

Will begin in 10 sec.

Please leave the room.

---------

AUTO SETUP START

[RETURN]:Cancel

(After 3 min.)

Press ENTER key to confirm the

results.

The measurement result is saved.

Remove the IntelliBeam microphone.

Initial screen appears.

Keep the IntelliBeam microphone in a safe place.

The measurement results are stored in the internal

memory of this unit until you run the AUTO SETUP

procedure again or configure the settings manually.

You can save the several measurement result using

memory setting function (☞p. 16).

AUTO SETUP COMPLETE

Please remove the MIC

from Sound Projector

and the listening position.

• If an error occurs, an error buzzer sounds and an error message is

displayed. For details on error messages, see “Error messages for

AUTO SETUP” (☞p. 15).

• If “ENVIRONMENT CHECK:Failure” is displayed, refer to “Error

messages for AUTO SETUP” (☞p. 15), press RETURN key, and

then run the AUTO SETUP procedure again.

• Depending on the environment of your listening room, the beam

angles of front right and left and surround left and right may be set to

the same value even if “BEAM MODE :5 Beam” is displayed as a

result.

If you do not want to reflect the results, press RETURN key.

When AUTO SETUP is performed from SETUP MENU, menu selection

screen of SETUP MENU appears.

4) y 5) y

6) y

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 454 455

Comments to this Manuals

No comments

Yamaha YRS-2100 Manual Page 15

Comments to this Manuals

Related products and manuals for Receiver Yamaha YRS-2100