Yamaha YRS-2100 Manual download pdf (Page 14)

100

101

Initial settings

12 En

Using AUTO SETUP (IntelliBeam)

Turn the unit and your TV on.

Switch TV’s input to “VIDEO INPUT 1

(example)”.

Connect the supplied IntelliBeam

microphone to the INTELLIBEAM MIC jack.

The jack is on the underside of the main unit.

• It is normal for loud test tones to be output during the AUTO

SETUP procedure. Make sure that there are no children around

in the listening room while the AUTO SETUP procedure is in

progress.

• Make sure that your listening room is as quiet as possible. For

accurate measurement, turn off air conditioner or other devices

that make noises.

• If there are curtains in your listening room, we recommend

following the procedure below.

1 Open the curtains to improve sound reflection.

2 Run “BEAM OPTIMIZE ONLY”.

3 Close the curtains.

4 Run “SOUND OPTIMIZE ONLY”.

Note

IntelliBeam microphone

When pressing RETURN key displays the setup menu

Press SETUP key repeatedly and display the menu screen again, then

select: “AUTO SETUP”  “BEAM+SOUND OPTIMIZE”.

When the screen is not displayed

Confirm the case below.

– The input jack of your TV and the video output jack of the unit are

connected.

– The input of your TV is set to “VIDEO INPUT 1 (example)”.

“BEAM+SOUND OPTIMIZE” is selected automatically. When you

perform “BEAM OPTIMIZE ONLY” or “SOUND OPTIMIZE ONLY”

only, refer to “AUTO SETUP via setup menu (☞p. 14)”.

• Wait outside the room during the AUTO SETUP procedure.

• The AUTO SETUP procedure takes about 3 minutes.

• To cancel the AUTO SETUP procedure after it is started, press

RETURN key.

1) y 2) y

3) y

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 454 455

Comments to this Manuals

No comments

Yamaha YRS-2100 Manual Page 14

Comments to this Manuals

Related products and manuals for Receiver Yamaha YRS-2100