Yamaha RX-A870 Owner's Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 162
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
En 23
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Y
When using only one surround back speaker, connect it to the SINGLE jack (L side).
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminals of the unit and
the speaker to each other, and the other is for the positive (+) terminals. If the wires are colored
to prevent confusion, connect the black wire to the negative and the other wire to the positive
terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable and twist
the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
4
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China and General models only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
1
2
SURROUND CENTER FRONT
SINGLE
SURROUND BACK
/
ZONE2
/
BI-AMP
/
ZONE2
SPEAKERS
SUBWOOFER
SURROUND
F.PRESENCE
EXTRA SP1
EXTRA SP2
1
67
2
3
45
9
9
ER
The unit (rear)
FRONT
11
2
2
4
4
33
+ (red)
- (black)
FRONT
11
2
2
Banana plug
Audio pin cable
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 161 162

Comments to this Manuals

No comments