Yamaha RX-A870 Owner's Manual Page 143
- Page / 162
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
En 143
Audio
The unit cannot be controlled using the remote
control.
The unit is out of the operating range. Use the remote control within the operating range (p.6).
The batteries are weak. Replace with new batteries.
The unit’s remote control sensor is exposed to direct sunlight or strong
lighting.
Adjust the lighting angle, or reposition the unit.
The remote control IDs of the unit and the remote control are not
identical.
Change the remote control ID of the unit or the remote control (p.136).
Problem Cause Remedy
No sound.
Another input source is selected. Select an appropriate input source with the input selection keys.
Signals that the unit cannot reproduce are being input.
Some digital audio formats cannot be played back on the unit. To check the audio
format of the input signal, use “Audio Signal” in the “Information” menu (p.134).
The cable connecting the unit and playback device is defective. If there is no problem with the connection, replace with another cable.
The volume cannot be increased.
The maximum volume is set. Use “Max Volume” in the “Setup” menu to adjust the maximum volume (p.121).
A device connected to the output jacks of the unit is not turned on. Turn on all devices connected to the output jacks of the unit.
No sound is coming from a specific speaker.
The playback source does not contain a signal for the channel. To check it, use “Audio Signal” in the “Information” menu (p.134).
The currently selected sound program/decoder does not use the
speaker.
To check it, use “Test Tone” in the “Setup” menu (p.120).
Audio output of the speaker is disabled.
Perform “Auto Setup” (p.42) or use “Configuration” in the “Setup” menu to change the
speaker settings (p.117).
The volume of the speaker is set too low.
Perform “Auto Setup” (p.42) or use “Level” in the “Setup” menu to adjust the speaker
volume (p.119).
The speaker cable connecting the unit and the speaker is defective. If there is no problem with the connection, replace with another speaker cable.
The speaker is malfunctioning.
To check it, replace with another speaker. If the problem persists, the unit may be
malfunctioning.
No sound is coming from the subwoofer.
The playback source does not contain LFE or low-frequency signals.
To check if the subwoofer is working properly, use “Test Tone” in the “Setup” menu
(p.120).
Subwoofer output is disabled. Perform “Auto Setup” (p.42) or set “Subwoofer” in the “Setup” menu to “Use” (p.118).
The volume of the subwoofer is too low. Adjust the volume on the subwoofer.
The subwoofer has been turned off by its auto-standby function. Disable the auto-standby function of the subwoofer or adjust its sensitivity level.
No sound from the playback device (connected to the
unit with HDMI).
The TV does not support HDCP (High-bandwidth Digital Content
Protection).
Refer to the instruction manuals for the TV and check the TV’s specifications.
The number of devices connected to the HDMI OUT jack exceeds the
limit.
Disconnect some of the HDMI devices.
Problem Cause Remedy
- Owner’s Manual 1
- CONTENTS 2
- CONFIGURATIONS 105 3
- APPENDIX 141 4
- Introduction 5
- About remote control 6
- FEATURES 7
- ⬛ AV CONTROLLER 8
- ⬛ AV SETUP GUIDE (for tablet) 8
- Google Play 9
- Part names and functions 10
- Front display (indicators) 12
- Rear panel 13
- Remote control 15
- PREPARATIONS 16
- 1 Connecting speakers 17
- Basic speaker configuration 18
- 5.1 system 19
- 2.1 system 20
- Presence speaker layout 20
- SP IMP.••8¬MIN 21
- ⬛ Connecting speakers 22
- The unit (rear) 23
- - (black) 23
- Banana plug 23
- Audio pin cable 23
- (Example) (Example) 24
- ⬛ Connecting Zone2 speakers 27
- SPEAKERS 28
- Input/output jacks and cables 29
- Connecting a TV 30
- ⬛ HDMI connection 31
- ⬛ Component video connection 32
- ⬛ Composite video connection 32
- Press ON SCREEN 33
- VIDEO AUX 35
- SURROUND CENTER 36
- TRIGGER OUT 38
- VOLTAGE SELECTOR 39
- ON SCREEN 40
- YPAO MIC 42
- (single measure) 44
- (multi measure) 45
- Error messages 48
- Warning messages 49
- The name of the unit 52
- Tap here to start setup 52
- Searching for an access point 54
- Using the PIN code 55
- Settings 56
- None, WPA2-PSK (AES) 56
- MusicCast CONTROLLER 58
- PLAYBACK 59
- SET Complete 60
- Sci-Fi 62
- ENTERTAINMENT 63
- CLASSICAL 63
- LIVE/CLUB 63
- STRAIGHT 65
- PURE DIRECT 66
- FM 87.50MHz 67
- FM 98.50MHz 67
- 02:Empty 68
- Operating the radio on the TV 69
- Press [ENTER] 70
- >>>------- 30% 70
- BBC Radio 4 70
- Daily Service 70
- BBC National 70
- 01:BBC Radio 4 71
- PRESET:01 71
- Program Type 72
- Classic Music 72
- 5A Level: 80 73
- FM 87.50MHz 74
- FM 98.50MHz 74
- 01:FM 98.50MHz 75
- Program Type 76
- CLASSICS 76
- BLUETOOTH 78
- Connected 80
- ⬛ Browse screen 81
- ⬛ Playback screen 82
- ⬛ Shuffle/repeat settings 82
- Media sharing setup 83
- Playback of PC music contents 84
- Playback of Internet radio 87
- Preparing Zone2 92
- Controlling Zone2 94
- Press PARTY 95
- 01:Empty 96
- Start the web browser 97
- Top menu screen 98
- Control screen 98
- Settings screen 99
- Audio Decoder 100
- †‡ Dsur 100
- Tone Control 101
- ⬛ Tone Control (Tone Control) 102
- ⬛ YPAO Volume (YPAO Volume) 102
- ⬛ Dialogue (Dialog) 102
- ⬛ Enhancer (Enhancer) 103
- ⬛ FM Mode (FM Mode) 104
- CONFIGURATIONS 105
- ⬛ Rename/Icon Select 106
- ⬛ Audio In 106
- ⬛ Decoder Mode 107
- ⬛ Volume Interlock 107
- ⬛ DMC Control 107
- Scene menu items 108
- (DSP Program menu) 110
- DSP Program menu items 111
- ⬛ Settings for decoders 112
- Setup menu items 114
- Menu Item Function Page 116
- Speaker (Manual Setup) 117
- ⬛ Distance 119
- ⬛ Parametric EQ 119
- ⬛ Test Tone 120
- ⬛ Lipsync 120
- Adjustment 121
- ⬛ Object Decode Mode 122
- ⬛ Video Mode 122
- ⬛ HDMI Control 123
- ⬛ Audio Output 124
- ⬛ Standby Through 124
- ⬛ Network Connection 125
- ⬛ IP Address 125
- ⬛ Network Standby 125
- ⬛ MAC Address Filter 126
- ⬛ Network Name 126
- Bluetooth 127
- Multi Zone 128
- ⬛ Party Mode Set 129
- Function 130
- ⬛ Trigger Output 131
- ⬛ Memory Guard 131
- ⬛ Auto Power Standby 132
- ⬛ ECO Mode 132
- (Information menu) 133
- Types of information 134
- (ADVANCED SETUP menu) 135
- TU••••FM50/AM9 136
- MON.CHK••••YES 137
- DTS MODE•MODE1 138
- INIT••••CANCEL 138
- UPDATE•••••USB 138
- VERSION••xx.xx 138
- Cursor keys 139
- UPDATE ENTER 140
- APPENDIX 141
- Troubleshooting 142
- USB and network 147
- Glossary 150
- ⬛ Audio information (others) 151
- HDMI and video information 152
- Network information 152
- Yamaha technologies 152
- Supported devices 153
- File formats 153
- Video signal flow 154
- Information on HDMI 155
- Audio Return Channel (ARC) 156
- HDMI signal compatibility 157
- Trademarks 158
- Specifications 159
- Compatible Decoding Formats 160
- Audio Section 160
- YJ203A0/EN2 162
Related products and manuals for Car media receivers Yamaha RX-A870
Car media receivers Yamaha R-N500 Manual
(120 pages)
(120 pages)
Car media receivers Yamaha R-N803 Owner's Manual
(216 pages)
(216 pages)
(76 pages)
Car media receivers Yamaha R-N602 Owner's Manual
(507 pages)
(507 pages)
Car media receivers Yamaha R-N602 Owner's Manual
(130 pages)
(130 pages)
© 2020, manymanuals.com. All rights reserved. | 0.250 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals