Yamaha RX-V595a Owner's Manual download pdf (Page 38)

PLAYING A SOURCE WITH THE DIGITAL SOUND FIELD PROCESSOR (DSP)

EFFECT

Follow steps 1 to 7 shown in “TO PLAY A SOURCE” on

pages 26 to 27.

Select the desired DSP program that is suitable for the source.

Front panel Remote control

Press DSP. While the indicator is lit up for about

three seconds, select a DSP program with the

numeric buttons (1 to 8).

* If the SELECTOR DIAL is set to the DSP position, you can

also select a DSP program directly with the numeric

buttons (1 to 8).

The name of the selected program appears

on the display.

If desired, adjust the delay time and the output level of each

speaker. (See pages 39 and 40 for details.)

The following indicators on the display show you what sound

processing is being undertaken.

12 3 4 5

1 This lights up in orange when a DVD source encoded with

DTS is played back and DTS is decoded.

2 This lights up in red when an LD source or a CD source

encoded with DTS is played back and DTS is decoded.

3 This lights up when Dolby Digital is being decoded and the

signals of the selected source encoded with Dolby Digital is

not in 2-channel.

4 This lights up when the digital sound field processor is

turned on.

5 This lights up when Dolby Surround is being decoded by

Dolby Pro Logic.

TO CANCEL THE SOUND EFFECT

To cancel the sound effect and monitor only the main sound,

press EFFECT or EFCT ON/OFF. Press EFFECT or EFCT

ON/OFF once more to turn sound effect back on.

Front panel Remote control

Notes

• You can select a program for each of the input sources.

Once you select a program, it is linked with the input source

selected at that time. So, when you select the input source

next time, the same program is automatically called up.

• When a monaural sound source is being played with DOLBY

PRO LOGIC or DOLBY PRO LOGIC ENHANCED, no sound

will be heard from the main speakers and the rear speakers.

Sound can only be heard from the center speaker. However,

if the NONE position is selected for “CNTR” in the SET

MENU mode, the main speakers will output the sound of the

center channel.

• When the source of signals input to the EXTERNAL

DECODER INPUT terminals of this unit is selected, DSP

cannot be used.

• If the sound effect is canceled when signals encoded with

Dolby Digital or DTS are input to this unit, the signals of all

channels are mixed and are output from the main speakers.

• If EFFECT or EFCT ON/OFF is pressed to turn the sound

effects off when Dolby Digital or DTS is decoded, it may

happen that the sound is output faintly or not output normally,

depending on the source. In that case, press EFFECT or

EFCT ON/OFF to turn on the sound effects.

If you change the LD (or CD) being played back with DTS

being decoded to another disc that is not encoded with DTS

when the red “dts” indicator lights up, playing back the newly

selected disc will result in no sound output. In this state, the

red “dts” indicator flashes to show that this unit is locked in

the DTS-decoding mode.

To play back the disc normally, change the current DTS-

decoding mode to another mode by INPUT MODE on the

front panel or by INPUT on the remote control so that the red

“dts” indicator goes off.

01RX-V595a-e/f4 6/24/99, 11:45 AM38

1 ... 37 38 39 ... 63

Comments to this Manuals

No comments

Yamaha RX-V595a Owner's Manual Page 38

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V595a