CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En 42
4
Connect the YPAO microphone to the YPAO
MIC jack on the front panel.
“Mic On View ON SCREEN” appears on the front
panel display, and the following display appears on the
front panel display or TV screen.
5
Press iCursor B / C to select the “Multi
Position” and press iENTER to set the
number of listening positions to measure.
To measure at the multiple listening positions (up to 8),
press
iCursor B / C to select “Yes” and press
iENTER.
To measure at one listening position, press
iCursor B / C to select “No” and press iENTER.
6
Press iCursor B / C repeatedly to select
the “Measure” and press iENTER to start
measurement.
Auto measurement starts in 10 seconds.
Display during measurement
RETURN
ENTER
R
E
ECEIVE
DI
-A
B
LTI
ET
H
N
D
K
B
A
i
ENTERtoStart
Measurement
YPAO
VOLUME
“Multi Position” is set to “Yes” at initial factory
settings. If not necessary, skip this step.
This completes preparation. To achieve more accurate
results, take note of the following when measuring
acoustics.
• It takes a few minutes to accurately measure acoustics
for one position. Keep the room as quiet as possible
while acoustics are measured.
• Wait in a corner of the room, or leave it entirely, while
acoustics are measured to avoid creating an
obstruction between the speakers and the YPAO
microphone.
>YesNo
MLT.Position
YPAO
VOLUME
• To start the measurement immediately, press
iENTER again.
• To cancel the automatic setup, press
iRETURN and
then
iENTER.
Progress0%
Measuring...
YPAO
VOLUME
Continues to the
next page
Comments to this Manuals