Yamaha RX-A2000 Owner's Manual download pdf (Page 138)

En 138

APPENDIX

Troubleshooting

Bluetooth™ Remote control

Display Cause Remedy

See

page

Searching... The Yamaha Bluetooth Wireless

Audio Receiver and the Bluetooth

component are in the process of

pairing.

—

The Yamaha Bluetooth Wireless

Audio Receiver and the Bluetooth

component are in the process of

establishing a connection.

—

Completed The pairing is completed. —

Canceled The pairing is canceled. —

BT connected The connection between the

Yamaha Bluetooth Wireless Audio

Receiver and the Bluetooth

component is established.

—

Disconnected The Bluetooth component is

disconnected from the Yamaha

Bluetooth Wireless Audio

Receiver.

—

Not found The Bluetooth component is not

found.

During pairing:

– pairing must be performed on the

Bluetooth component and this unit

simultaneously. Check if the Bluetooth

component is in pairing mode.

During connecting:

– check if the Bluetooth component is

turned on.

– check if the Bluetooth component is

within 10 m of the Yamaha Bluetooth

Wireless Audio Receiver.

—

Pairing may not have been

achieved.

Try pairing again. 77

Problem Cause Remedy

See

page

The remote control

does not work or

function properly.

Wrong distance or angle. The remote control will function within a

maximum range of 6 m, and no more than

30 degrees off-axis from the front panel.

—

Direct sunlight or lighting (from

an inverter type of fluorescent

lamp, strobe light, etc.) is striking

the remote control sensor of this

unit.

Adjust the lighting angle, or reposition this

unit.

—

The batteries are weak. Replace all batteries. 13

The remote control ID of the

remote control and this unit do not

match.

Match the remote control ID of this unit and

the remote control.

112

122

The battery of

remote control runs

out immediately.

The power of battery is not

enough.

Replace the battery with alkaline battery. —

External components

cannot be controlled

using the remote

control.

The remote control code is not

correctly set.

Set the remote control code correctly using

“Remote control code search” on the CD-

ROM.

—

Try setting another code for the same

manufacturer using “Remote control code

search” on the CD-ROM.

—

If this unit does not work when you press

Cursor B / C / D / E, do the following.

When the key does not work during DVD

disc menu operation: press the Input

selector again.

When there is no response with remote

control operation of the Option menu/Setup

menu: press SOURCE/RECEIVER (it

should glow orange) and try operating the

remote control again.

—

Even if the remote control code is

correctly set, there are some

models that do not respond to the

remote control.

—

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 158 159

Comments to this Manuals

No comments