Yamaha RX-V3300 Manual Page 79
- Page / 95
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
75
English
INTRODUCTION PREPARATION
BASIC
OPERAIONT
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
■ Example of a system configuration and connections
Notes
• When not using the main room, turn down the volume of this unit in the main room. Adjust the Zone 2 volume with the control on
the amplifier in the second room.
• DO NOT USE the Zone 2 feature for CDs encoded with DTS to avoid unexpected noise.
ZONE 2
You can make up a multi-room audio-video system with this unit. This feature enables you to set this unit to reproduce
separate input sources in the main room and second room (Zone 2) with the supplied remote control in the second room.
Only analog signals are sent to the second room. For any source you want to listen to in the second room, you must
connect the analog output jack from the source to the corresponding analog input jack on this unit.
Zone 2 Connections
To use the multi-room functions of this unit, you need the following additional equipment:
• An infrared signal receiver in the second room
• An infrared emitter in the main room
This emitter transmits the infrared signals from the remote control in the second room to the main room
(for example, to a CD player or LD player).
• An amplifier and speakers for the second room
• A video monitor for the second room
REMOTE CONTROL OUT
DVD INPUT
REMOTE CONTROL IN
ZONE 2 VIDEO OUT
ZONE 2 AUDIO OUT
OUT
IN
OUT
IN
REMOTE
CONTROL OUT
Main room
Infrared signal
receiver
Remote control
Second room
Amplifier
Infrared emitter
This unit
DVD player
(or other component)
This unit
y
• Since there are so many ways to connect and use this unit in a
multi-room installation, we recommend that you consult with
the nearest authorized YAMAHA dealer or service center for
the Zone 2 connections which will best meet your
requirements.
• Some YAMAHA models are able to connect directly to the
REMOTE CONTROL OUT jack of this unit. If you own these
products, you may not need to use an infrared emitter. Up to 6
YAMAHA components can be connected as shown.
Video
monitor
0110V3300_75-76_EN(UA) 02.7.24, 6:07 PM75
- RX-V3300 1
- IMPORTANT SAFETY INSTRUCTIONS 2
- CAUTION II 3
- III CAUTION 4
- CONTENTS 5
- FEATURES 6
- GETTING STARTED 7
- CONTROLS AND FUNCTIONS 8
- Remote Control 10
- Using the Remote Control 11
- Front Panel Display 12
- Rear Panel 13
- SPEAKER SETUP 14
- Speaker Placement 15
- Connecting the Speakers 16
- COMPONENT VIDEO 17
- ■ IMPEDANCE SELECTOR switch 18
- CONNECTIONS 19
- Connecting Audio Components 22
- Connecting the Antennas 24
- Connecting to an External 25
- Amplifier 25
- Connecting to the 6CH INPUT 25
- ■ AC OUTLET(S) (SWITCHED) 26
- Turning on the Power 27
- ON-SCREEN DISPLAY (OSD) 28
- SPEAKER MODE SETTINGS 29
- TEST DOLBY SUR 30
- Before You Begin 30
- 3 Press –/+ repeatedly to 31
- 4 When the adjustment is 31
- TEST DSP 32
- BASIC PLAYBACK 33
- Input Modes and Indications 35
- 1 Set 10KEY/DSP to DSP on 36
- Selecting PRO LOGIC 37
- PRO LOGIC or Neo: 6 37
- Front panel 38
- Remote control 38
- Understanding Sound Fields 39
- Hi-Fi DSP Programs 39
- CINEMA-DSP 39
- Sound Field Effect 40
- Straight Decode 40
- Features of DSP Programs 41
- Automatic and Manual Tuning 45
- Presetting Stations 46
- A :AM 630 kHz 47
- C3:AM 630 kHz 47
- 2,41,31,3 48
- BASIC RECORDING 49
- REMOTE CONTROL FEATURES 50
- Setting the Manufacturer Code 51
- Learn Feature 52
- Display Window 53
- Using the Macro Feature 54
- ■ Operating the macro 55
- ■ Programming a macro 55
- Clearing Learned Functions 56
- Macros, Renamed Source Names 56
- Clearing a Macro Function 57
- Clearing a Learned Function 57
- Each Component Control Area 59
- SAT area) 60
- PARAMETER 64
- SET MENU 64
- 1 SPEAKER SET (speaker mode 65
- 1C REAR L/R SP 66
- ■ 1E LFE/BASS OUT (bass out 67
- ■ 1D REAR CT SP (rear center 67
- 1G MAIN LEVEL 68
- 2 LOW FRQ TEST 69
- 3 L/R BALANCE (balance of the 69
- 6 INPUT RENAME 70
- 5 CENTER GEQ (center graphic 70
- 7 I/O ASSIGNMENT 71
- 9 PARAM. INI (parameter 72
- 10 LFE LEVEL 72
- 8 INPUT MODE (initial input 72
- 11 D-RANGE (dynamic range) 73
- 12 SP DELAY 73
- 13 DISPLAY SET 74
- 14 MEMORY GUARD 75
- 15 6CH INPUT SET 75
- 16 ZONE2 SET 76
- SP OUT…………………OFF 76
- ≥ OUTPUT VOL……VAR 76
- 1 Set PARAMETER/SET 77
- SLEEP TIMER 78
- Zone 2 Connections 79
- Remote Control in Zone 2 80
- What Is a Sound Field? 81
- 60 dB 60 dB 60 dB 85
- TROUBLESHOOTING 87
- ■ Remote control 91
- GLOSSARY 92
- SPECIFICATIONS 94
Related products and manuals for Receiver Yamaha RX-V3300
Receiver Yamaha DSP-E580 Owner's Manual
(38 pages)
(38 pages)
Receiver Yamaha RX-V692RDS Owner's Manual
(55 pages)
(55 pages)
Receiver Yamaha R-S500 Manual
(383 pages)
(383 pages)
Receiver Yamaha HTR-6090 Manual
(152 pages)
(152 pages)
Receiver Yamaha RX-V1500 Owner's Manual
(700 pages)
(700 pages)
Receiver Yamaha RX-V2600 Manual
(144 pages)
(144 pages)
Receiver Yamaha DSP-AZ2 Owner's Manual
(576 pages)
(576 pages)
Receiver Yamaha RX-V393RDS Owner's Manual
(46 pages)
(46 pages)
Receiver Yamaha RX-V2200 Manual
(88 pages)
(88 pages)
Receiver Yamaha HTR-6080 Manual
(125 pages)
(125 pages)
Receiver Yamaha RX-V3200 Manual
(88 pages)
(88 pages)
Receiver Yamaha YRS-1100 Owner's Manual
(116 pages)
(116 pages)
Receiver Yamaha YSP-1100 Owner's Manual
(284 pages)
(284 pages)
Receiver Yamaha HTR-3063 Manual
(61 pages)
(61 pages)
Receiver Yamaha RX-V563 Manual
(298 pages)
(298 pages)
Receiver Yamaha RX-V2600 Owner's Manual
(903 pages)
(903 pages)
Receiver Yamaha RX-V471 User Manual
(2 pages)
(2 pages)
Receiver Yamaha RX-V367 Owner's Manual
(61 pages)
(61 pages)
Receiver Yamaha YRS-2100 Manual
(455 pages)
(455 pages)
Receiver Yamaha RX-V563 Owner's Manual
(202 pages)
(202 pages)
© 2020, manymanuals.com. All rights reserved. | 0.748 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals