Yamaha CRW2200S Owner's Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 70
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
SCSI Connection Set Up
21
SCSI ID Number
Each of the SCSI devices connected to the computer is identified by its SCSI ID
number. You need to assign a number from “0” to “7” for each SCSI device.
Commonly, ID number “7” is reserved for the computer’s SCSI card itself.
Therefore, the CRW2200S can actually be assigned an ID number from “0” to
“6.” The ID number is set by attaching/detaching the shunts on the ID Select
jumper switches according to the diagram shown below.
Note
The SCSI ID number for each device on the chain must be unique. Make sure the
CRW2200S
’s SCSI ID number is not the same as that of any other device on the chain. By
factory default, the
CRW2200S
is assigned ID number “3” but this can be changed.
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
ID SELECT
PARITY
TERMINATOR
BLOCK SIZE
124
SCSI ID 6 SCSI ID 7
SCSI ID 3 (Default) SCSI ID 4 SCSI ID 5
SCSI ID 0 SCSI ID 1 SCSI ID 2
Page view 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 69 70

Comments to this Manuals

No comments