Yamaha CRW2200S Owner's Manual download pdf (Page 25)

SCSI Connection Set Up

Setting the Jumper Switches

8 Before fitting the CRW2200S into the computer, you need to set up the

drive using the jumper switches located at the rear of the unit. You’ll

need to set the following:

➀ SCSI ID number

➁ Parity check

➂ Termination

➃ Block size

To set each jumper switch, you have to bridge the two pins in the respective

column of the grid with a plastic shunt. Shunts are already attached to the jumper

switches in their default configurations.

Note

The plastic shunts actually contain metal for bridging the two pins of a jumper switch,

creating an electrical connection between them when attached. When removed, the jumper

switch is set to “OFF.” Store unused shunts in a safe place where they will not be lost.

Use a pair of long-nosed pliers to attach or detach the plastic shunts

accordingly. Make sure that the computer is turned off beforehand.

ID SELECT

PARITY.

TERMINATOR

BLOCK SIZE

124

Jumper switches

Rear Panel

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 69 70

No comments

Yamaha CRW2200S Owner's Manual Page 25