Yamaha RAPTOR 250 Service Manual Page 282

  • Download
  • Add to my manuals
  • Print
  • Page
    / 311
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 281
ELEC
7-15
EBS01050
TROUBLESHOOTING
Check:
1. fuse
2. battery
3. starter motor
4. starting circuit cut-off relay
5. starting circuit cut-off relay (diode)
6. starter relay
7. main switch
8. engine stop switch
9. neutral switch
10.clutch switch
11.start switch
12.wiring connections
(of the entire starting system)
N
O
TE:N
O
TE:
Before troubleshooting, remove the following
part(s):
1. seat
2. front panel
3. front fender
4. rear fender
5. side cover
Troubleshoot with the following special
tool(s).
EBS01043
EBS01044
EBS01051
1. Fuse
Check the fuse for continuity.
Refer to “CHECKING THE SWITCHES”.
Is the fuse OK?
YES
NO
Replace the fuse.
The starter motor fails to turn.
Pocket tester
90890-03112, YU-03112-C
2. Battery
Check the condition of the battery.
Refer to “CHECKING AND CHARGING
THE BATTERY” in chapter 3.
Minimum open-circuit voltage
12.8 V or more at 20°C (68°F)
Is the battery OK?
YES
NO
Clean the battery
terminals.
Recharge or replace
the battery.
3. Starter motor
Connect the positive battery terminal
and starter motor lead with a jumper
lead .
WARNING
A wire that is used as a jumper lead
must have at least the same capacity or
more as that of the battery lead, other-
wise the jumper lead may burn.
This check is likely to produce sparks,
therefore make sure nothing flammable
is in the vicinity.
Does the starter motor turn?
YES
NO
Repair or replace
the starter motor.
ELECTRIC STARTING SYSTEM
Page view 281
1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 310 311

Comments to this Manuals

No comments