Yamaha RAPTOR 250 Service Manual Page 299

  • Download
  • Add to my manuals
  • Print
  • Page
    / 311
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 298
ELEC
7-32
EBS01073
TROUBLESHOOTING
Check:
1. fuse
2. battery
3. main switch
4. wiring connections
(of the entire signaling system)
N
O
TE:N
O
TE:
Before troubleshooting, remove the following
part(s):
1. seat
2. front fender
Troubleshoot with the following special
tool(s).
EBS01043
EBS01044
EBS01041
EBS01074
Any of the following fail to light: brake
light or an indicator light.
1. Fuse
Check the fuse for continuity.
Refer to “CHECKING THE SWITCHES”.
Is the fuse OK?
YES
NO
Replace the fuse.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
2. Battery
Check the condition of the battery.
Refer to “CHECKING AND CHARGING
THE BATTERY” in chapter 3.
Minimum open-circuit voltage
12.8 V or more at 20°C (68°F)
Is the battery OK?
YES
NO
Clean the battery
terminals.
Recharge or replace
the battery.
3. Main switch
Check the main switch for continuity.
Refer to “CHECKING THE SWITCHES”.
Is the main switch OK?
YES
NO
Replace the main
switch.
4. Wiring
Check the entire signal system’s wiring.
Refer to “CIRCUIT DIAGRAM”.
Is the signaling system’s wiring properly
connected and without defects?
YES
NO
Check the condition
of each of the signal-
ing system’s circuits.
Refer to “CHECK-
ING THE SIGNAL-
ING SYSTEM”.
Properly connect or
repair the signaling
system’s wiring.
SIGNAL SYSTEM
Page view 298
1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 310 311

Comments to this Manuals

No comments