Yamaha RAPTOR 250 Service Manual Page 128

  • Download
  • Add to my manuals
  • Print
  • Page
    / 311
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 127
ENG
4-12
b. Remove the screwdriver and slowly release
the timing chain tensioner rod.
c. Make sure that the timing chain tensioner
rod comes out of the timing chain tensioner
housing smoothly. If there is rough move-
ment, replace the timing chain tensioner.
3. Check:
• Cap bolt
• Copper washer
•Spring
•One-way cam
• Timing chain tensioner rod
Damage/wear Replace the defective
part(s).
INSTALLING THE CYLINDER HEAD
1. Install:
• Cylinder head gasket
• Dowel pins
2. Install:
• Cylinder head
• Copper washers
• Cylinder head bolts
3. Tighten:
• Cylinder head bolts
N
O
TE:N
O
TE:
Apply oil to the bearing surface of (upper) cyl-
inder head bolt.
Further, apply molybdenum disulfide grease
to thread part.
Tighten the cylinder head bolts in the proper
tightening sequence as shown.
4. Install:
• Camshaft sprocket
• Dowel pin
• Timing chain
Cylinder head bolt 226 mm (8.90 in)
24 Nm (2.4 m•kg, 18 ft•lb)
Cylinder head bolt 45 mm (1.77 in)
20 Nm (2.0 m•kg, 15 ft•lb)
CYLINDER HEAD
Page view 127
1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 310 311

Comments to this Manuals

No comments