DTX700 Owner’s Manual
35
Basic Operation
Building Your Own Kit
With the DTX700, you can easily adjust the snare wire for the
snare pad (i.e., the pad plugged into the [qSNARE] trigger
input jack). In the case of pads featuring a pad controller, simply
turn the controller to adjust the snare wire setting.
Meanwhile, the following procedure can be used to adjust the
setting for pads not featuring a pad controller.
1 Press the [KIT] button.
2 Turn the dial to choose a kit.
3 Press the [INST] button.
4 Hit the snare pad (i.e., the pad plugged into
the [qSNARE] trigger input jack).
5 Hold down the [SHIFT] button and press the
[F2] button.
6 Turn the dial to adjust the snare wire.
Higher values correspond to tighter snare wires and vice-
versa. An “off” setting implies that the snare wire has been
fully removed from the snare.
7 Press the [STORE] button.
8 Press the dial to store your new setting.
NOTE
• The Snares function is displayed only for the pad con-
nected via the [qSNARE] trigger input jack.
Adjusting the Snare Wire
dtx700_en_om.book Page 35 Friday, December 17, 2010 4:34 PM
Comments to this Manuals