Yamaha F40F Owner's Manual download pdf (Page 93)

Maintenance

87

EMU30662

Removing propeller

EMU29197

Spline models

1. Straighten the cotter pin and pull it out

using a pair of pliers.

2. Remove the propeller nut, washer, and

spacer (if equipped). WARNING! Do

not use your hand to hold the propel-

ler when loosening the propeller nut.

[EWM01890]

3. Remove the propeller, washer (if

equipped), and thrust washer.

EMU30672

Installing propeller

EMU29234

Spline models

NOTICE

ECM00501

Make sure to use a new cotter pin and

bend the ends over securely. Otherwise,

the propeller could come off during oper-

ation and be lost.

1. Apply Yamaha marine grease or a corro-

sion resistant grease to the propeller

shaft.

2. Install the spacer (if equipped), thrust

washer, washer (if equipped), and pro-

peller on the propeller shaft. NOTICE:

Make sure to install the thrust washer

before installing the propeller. Other-

wise, the lower case and propeller

boss could be damaged.

[ECM01881]

3. Install the spacer (if equipped) and the

washer. Tighten the propeller nut to the

specified torque.

4. Align the propeller nut with the propeller

shaft hole. Insert a new cotter pin in the

hole and bend the cotter pin ends.

NOTICE: Do not reuse the cotter pin.

Otherwise, the propeller can come off

during operation.

[ECM01891]

TIP:

If the propeller nut does not align with the

propeller shaft hole after tightening to the

specified torque, tighten the nut further to

align it with the hole.

EMU2928B

Changing gear oil

WARNING

EWM00800

 Be sure the outboard motor is securely

fastened to the transom or a stable

1. Cotter pin

2. Propeller nut

3. Washer

4. Spacer

5. Propeller

6. Thrust washer

Propeller nut tightening torque:

35 Nm (3.57 kgf-m, 25.8 ft-lb)

6BG-9-39-1E0.book 87 ページ２０１３年４月２９日　月曜日　午前９時４１分

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 111 112

Comments to this Manuals

No comments