Yamaha F40F Owner's Manual download pdf (Page 34)

Components

28

EMU31432

Steering friction adjuster

A friction device provides adjustable resis-

tance to the steering mechanism, and can be

set according to operator preference. An ad-

juster lever is located on the bottom of the

tiller handle bracket.

To increase resistance, turn the lever to the

port side “A”.

To decrease resistance, turn the lever to the

starboard side “B”.

WARNING

EWM00040

Do not overtighten the friction adjuster. If

there is too much resistance, it could be

difficult to steer, which could result in an

accident.

If the resistance does not increase even

when the lever is turned to the port side “A”,

make sure that the nut is tightened to the

specified torque.

TIP:

 Steering movement is blocked when the

adjuster lever is set to the “A” position.

 Check the tiller handle for smooth move-

ment when the lever is turned to the star-

board side “B”.

 Do not apply lubricants such as grease to

the friction areas of the steering friction ad-

juster.

EMU26143

Power trim and tilt switch on remote

control or tiller handle

The power trim and tilt system adjusts the

outboard motor angle in relation to the tran-

som. Pressing the switch “ ” (up) trims the

outboard motor up, and then tilts it up. Press-

ing the switch “ ” (down) tilts the outboard

motor down and trims it down. When the

switch is released, the outboard motor will

stop in its current position.

For instructions on using the power trim and

tilt switch, see pages 63 and 65.

ZMU02810

B

A

1. Nut

Nut tightening torque:

6 Nm (0.61 kgf-m, 4.4 ft-lb)

6BG-9-39-1E0.book 28 ページ２０１３年４月２９日　月曜日　午前９時４１分

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 111 112

Comments to this Manuals

No comments