Yamaha F40F Owner's Manual download pdf (Page 35)

Components

29

EMU26155

Power trim and tilt switch on bottom

cowling

The power trim and tilt switch is located on

the side of the bottom cowling. Pushing the

switch “ ” (up) trims the outboard motor up,

and then tilts it up. Pushing the switch “ ”

(down) tilts the outboard motor down and

trims it down. When the switch is released,

the outboard motor will stop in its current po-

sition.

For instructions on using the power trim and

tilt switch, see page 65.

WARNING

EWM01031

Use the power trim and tilt switch located

on the bottom cowling only when the boat

is at a complete stop with the engine off.

Attempting to use this switch while the

boat is moving could increase the risk of

falling overboard and could distract the

operator, increasing the risk of collision

with another boat or an obstacle.

EMU30901

Variable trolling RPM switches

The trolling speed can be adjusted when the

outboard motor is trolling. Press the “ ”

switch to increase the trolling speed and

press the “ ” switch to decrease the trolling

speed.

TIP:

 The trolling speed changes approximately

50 r/min each time a switch is pressed.

 If the trolling speed has been adjusted, the

engine returns to the normal trolling speed

when the engine is stopped and restarted

or when the engine speed exceeds ap-

1. Power trim and tilt switch

1. Variable trolling RPM switch

UP

DN

1

ZMU06394

6BG-9-39-1E0.book 29 ページ２０１３年４月２９日　月曜日　午前９時４１分

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 111 112

Comments to this Manuals

No comments