Yamaha F40F Owner's Manual download pdf (Page 64)

Operation

58

2. Attach the engine shut-off cord to a se-

cure place on your clothing, or your arm

or leg. Then install the clip on the other

end of the cord into the engine shut-off

switch.

3. Turn the main switch to “ ” (on).

4. Turn the main switch to “ ” (start),

and hold it for a maximum of 5 seconds.

5. Immediately after the engine starts, re-

lease the main switch and allow it to re-

turn to “ ” (on). NOTICE: Never turn

the main switch to “ ” (start)

while the engine is running. Do not

keep the starter motor turning for

more than 5 seconds. If the starter

motor is turned continuously for

more than 5 seconds, the battery will

be quickly discharged, thus making it

impossible to start the engine. The

starter can also be damaged. If the

engine will not start after 5 seconds

of cranking, return the main switch to

“ ” (on), wait 10 seconds, then

crank the engine again.

[ECM00192]

TIP:

 When the engine is cold, it needs to be

warmed up. For further information, see

page 59.

 If the engine is warm and fails to start,

open the throttle slightly and try to start the

engine again. If the engine still fails to

start, see page 92.

EMU36510

Checks after starting engine

EMU36523

Cooling water

Check for a steady flow of water from the

cooling water pilot hole. A continuous flow of

water from the pilot hole indicates that the

water pump is pumping water through the

cooling water passages. If the cooling water

passages are frozen, it may take a while for

water to start flowing out of the pilot hole.

NOTICE

ECM01810

If water is not flowing out of the pilot hole

at all times while the engine is running,

overheating and serious damage could

occur. Stop the engine and check wheth-

er the cooling water inlet on the lower

case or the cooling water pilot hole is

blocked. Consult your Yamaha dealer if

the problem cannot be located and cor-

rected.

6BG-9-39-1E0.book 58 ページ２０１３年４月２９日　月曜日　午前９時４１分

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 111 112

Comments to this Manuals

No comments