Yamaha 02R96-v2 Owner's Manual download pdf (Page 141)

Surround Monitoring 141

02R96 Version 2—Owner’s Manual

You can set the Bass Management parameters in the following ranges:

The HPF 1, 2, 3, and LPF 1 & 2 values indicate a cut-off frequency and a filter response. For example,

“80-12” means a cutoff frequency of 80 Hz and a filter response of –12 dB/octave.

“L” means Linkwitz filter. Other filters are Butterworth.

MONITOR ALIGNMENT ATT & DLY ON/OFF:

These buttons are used to turn on and off the Monitor

Alignment Attenuator and Delay parameters of all Sur-

round speakers. The MONITOR ALIGNMENT diagram

and Surround Channel Attenuator and Delay parameters,

which are displayed when either of these buttons are

selected, allow you to align the surround monitor speak-

ers by attenuating and delaying Surround Channels as

necessary. The Attenuator parameters can be set –∞,

–12 dB to +12 dB in 0.1 dB steps. The Delay parameters

can be set from 0 to 30 msec in 0.02 msec steps.

Patching Slot Inputs to Surround Channels

Individual Slot Inputs can be patched to Surround Monitor Channels as follows.

1 Use the MONITOR [DISPLAY] button to locate the Surround Monitor Patch

page.

2 Use the cursor buttons to select the parameters, and use the Parameter

wheel, INC/DEC buttons, and [ENTER] button to set them.

SLOT/CH: This patching matrix is used to patch Inputs 1–16 from each of the four Slots

to the Surround Monitor Channels. Each Slot Input can be patched to only one Surround

Monitor Channel.

LEVEL: These parameters are used to set the monitor level of each Slot.

Parameters Range

HPF 1, 2, 3

THRU, 80-12, 80-12L, 80-24, 80-24L

LPF1

THRU, 80-24, 80-24L, 120-42

LPF2

THRU, 80-24, 80-24L, MUTE

ATT 1 & 2

0 to –12 dB (1 dB steps)

AMP

0 to +12 dB (1 dB steps)

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 349 350

No comments

Yamaha 02R96-v2 Owner's Manual Page 141