Yamaha RX-Z7 Owner's Manual download pdf (Page 36)

36 En

Optimizing the speaker setting for your listening room

It is recommended that you use a tripod (etc.) to affix the

optimizer microphone at the same height as your ears

would be when you are seated in your listening position.

You can use the attached screw of a tripod (etc.) to fix the

optimizer microphone to the tripod (etc.).

3 Press 9ENTER to start the measurement.

This unit starts to count down from 10 seconds.

• To start the measurement immediately, press 9ENTER

again.

• To cancel the automatic setup and return to the previous

screen, press ?RETURN and then 9ENTER.

Loud test tones are output from each speaker during

the measurement. Once all items are measured,

“COMPLETED” appears.

If an error or warning message appears, see “Automatic

setup” (page 145).

4 Disconnect the optimizer microphone to

complete the automatic setup.

You can check the results of the measurements by using

the GUI screen (page 40).

Use this feature to optimize the setup of this unit for one

listening position. You can also select the parameters to be

optimized in the automatic setup.

1 Turn on the video monitor and then follow

steps 1 and 2 in “Quick automatic setup”

(page 35).

2 Press IMENU on the remote control.

The following screen (GUI menu) appears in the

video monitor.

3 To select the parameters to be optimized,

press 9k to select “Setup Menu” and then

press 9h.

When you do not need to select the parameters to be

optimized, skip to step 6.

If you do not select the parameters to be optimized, this

unit will optimize the parameters you selected last time.

All the parameters except “Angle” are selected by the

initial factory settings.

4 Press 9k / n repeatedly to select the

parameter and then press 9ENTER to

check or uncheck the box.

Check the boxes for the parameters to be optimized.

Before proceeding next operation

Once you perform the next operation, this unit starts the

automatic setup procedure in 10 seconds. During the automatic

setup procedure, do not perform any operation on this unit. For

more accurate measurements, we recommended that you get out

of the room or move to the wall where speakers are not around

during the measurement. It takes approximately 3 minutes.

Note

Optimizer microphone

COMPLETED

PLS UNPLUG MIC

ERROR: E-01

PRESS ENTER

Basic automatic setup

Parameter Descriptions

Multi Measure

(Multiple point

measurement)

You can optimize the setup of this unit for

multiple listening positions. For details, see

“Advanced automatic setup” (page 38). In

the basic automatic setup, leave this setting

to the default.

Wiring

(Speaker wiring)

This unit checks and adjusts which speakers

are connected and the polarity of each

speaker.

Distance

(Speaker distance)

This unit checks and adjusts the distance of

each speaker from the listening position and

adjusts the timing of each channel.

Size

(Speaker size)

This unit checks and adjusts the frequency

response of each speaker and sets the

appropriate low-frequency crossover for

each channel.

Information

Setup Menu

Start

NOTICE

Loud test tones are

output.

Please keep quiet

or leave the room.

Start:ENTER

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 177 178

Comments to this Manuals

No comments

Yamaha RX-Z7 Owner's Manual Page 36

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-Z7

Related products and manuals for Alarm clocks Sony ICF-C215