Yamaha HTR-7063 Owner's Manual download pdf (Page 39)

CONNECTIONS

Setting up the speaker parameters automatically (YPAO)

En 39

■

Message list

■ When a warning message is displayed before

measurement

■ Error messages

■ Warning messages

NOTE

If the following messages appear, resolve the problems that have

occurred and carry out the measurement process again.

Connect MIC! The YPAO microphone is

not connected.

Connect the YPAO

microphone to the YPAO

MIC jack on the front

panel.

Unplug HP! The headphones are

connected.

Remove the headphones.

Memory Guard! The settings of this unit

are protected.

Set “Memory Guard” in

the Setup menu to “Off”

(☞p. 92).

E-1:

No Front SP

The unit was not able to

find the front channel.

Check that the left and

right front speakers are

connected correctly.

E-2:

No Sur. SP

The unit was only able to

find one of side of the

surround channels.

Check that the left and

right surround speakers

are connected correctly.

E-3:

No F.PRNS SP

The unit was only able to

find one of side of the

presence channels.

Check that the left and

right presence speakers

are connected correctly.

E-4:

SBR→SBL

Only one surround back

speaker is connected and

only the right side

surround back channel

sound is detected.

When only one surround

back speaker is

connected, connect to the

left side (SINGLE)

terminal.

E-5:

Noisy

The noise is too loud,

preventing accurate

measurements from

being taken.

Measure again in quiet

surroundings. Turn off any

devices in the room that

may be emitting noise, or

place them further away

from the YPAO

microphone.

When this message is

displayed, selecting

“PROCEED” will allow

you to continue measuring.

However, we recommend

resolving the problem and

measuring again, as

continuing measurement

without doing so will not

give accurate results.

E-6:

Check Sur.

Even though surround

left and right speakers are

not connected, only the

surround back speakers

are connected.

When using surround back

speakers, connection of the

surround left/right

speakers is necessary.

E-7:

No MIC

The YPAO microphone

has been removed.

While measuring, take

care not to touch the

YPAO microphone.

E-8:

No Signal

The YPAO microphone

could not distinguish a

test tone.

Check that the YPAO

microphone has been

installed correctly.

Check that each speaker

has been connected and

installed correctly.

The YPAO microphone

or the YPAO MIC jack

may be broken. Inquire at

the retailer where you

purchased this unit, or the

nearest Yamaha service

center.

E-9:

User Cancel

You have carried out an

operation that has

cancelled the measuring

process.

Carry out the measuring

process again. Do not

operate this unit by, for

example, adjusting the

volume.

E-10:

Internal Error

An internal error has

occurred.

Carry out the measuring

process again. Contact a

Yamaha service center if

“E-10” is displayed

again.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 128 129

Comments to this Manuals

No comments

Yamaha HTR-7063 Owner's Manual Page 39

Comments to this Manuals

Related products and manuals for AV receivers Yamaha HTR-7063