Yamaha PSR8000 Owner's Manual download pdf (Page 91)

● AUTO TRIGGER LEVEL

For most applications the default AUTO TRIGGER LEVEL

setting of “–21.0dB” will provide satisfactory results. If you

want to trigger sampling at a lower or higher level, however, use

the AUTO TRIGGER LEVEL LCD dials to set the level any-

where from –47.6 to –0.3 dB. Below the “–47.6dB” setting is a

“MANUAL” mode in which automatic triggering does not

occur. In the MANUAL mode sampling begins immediately the

START LCD button is pressed.

● PRE EFFECT

Press the PRE EFFECT LCD button to go to the PRE EFFECT

display. This display page allows you to set up a maximum of

three DSP effects to be applied to the source sound as it is

sampled. The actual DSPs used and the default settings are:

Please note that the DSP blocks are connected in series: i.e.

DSP1 → DSP2 → DSP3.

To change a PRE EFFECT DSP setup, select the desired

DSP via the ▲ and ▼ LCD buttons to the left of the display. Use

the TYPE LCD dials to select an effect type, the PARAMETER

LCD dials to select any of the parameters available for the

selected effect type, and the VALUE LCD dials to change the

value of the selected parameter as required. For some effects the

WET/DRY parameter can be used to change the balance be-

tween the direct (“dry”) and effect (“wet”) sound as required.

Press the EXIT LCD button to return to the SAMPLING/

FILE IMPORT display when done.

● Importing Waves From Disk

To import previously-saved waveform files or standard WAV or

AIFF format files from disk, insert the appropriate disk into the

PSR-8000 floppy disk drive (not necessary if the file to be

loaded is on the optional internal hard disk), then press the FILE

IMPORT LCD button in the SAMPLING/FILE IMPORT

display.

If the optional hard disk is present, use the DIRECTORY

LCD dials to select the floppy disk or hard disk directory

containing the file(s) to be loaded. All loadable files within the

selected directory will be displayed in the FILE LIST. Use the

FILE LIST LCD dials to select the file you want to load, then

press the EXECUTE LCD button to load the file.

Press the EXIT LCD button to return to the SAMPLING/

FILE IMPORT display when done. After loading the amount

of remaining sampling time will be reduced by the size of the

loaded data.

• Since all PSR-8000 samples are monaural, stereo

DSP effects may not produce the expected sound.

• If the sample memory is full, or the selected file is

larger than the available sample memory, an alert

message will appear and loading will not be possible.

•A

icon between the FILE LIST number and file

name indicates a WAV or AIFF format wave file, while

icon indicates a waveform file.

Sampling

Sample DSP PSR-8000 DSP Block Default Settings

DSP1 DSP (MIC) NoiseGate

DSP2 DSP (LEAD) Thru

DSP3 DSP (RIGHT2) Thru

DSP1 DSP2 DSP3

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 205 206

Comments to this Manuals

No comments

Yamaha PSR8000 Owner's Manual Page 91

Comments to this Manuals

Related products and manuals for Synthesizer Yamaha PSR8000