Yamaha PSR8000 Owner's Manual download pdf (Page 158)

158

• The notch on the hard disk cover should be on the opposite

side from the connector and cable.

• Silver screws.

• Black screws.

• The notch in the hard disk cover should face towards

the rear panel.

BAttach the hard disk unit to the hard disk cover using the

four silver screws removed from the hard disk cover in

step X.

Depending on the type of hard disk drive you plan to

install, select holes q or holes w to attach the hard disk

drive.

* Holes q are used in this illustration.

• Be careful not to drop any screws inside the instrument during

installation (this can be prevented by keeping the hard disk unit

and cover away from the instrument while attaching). If this does

happen, be sure to remove the screw(s) from inside the unit before

turning the power on. Loose screws inside the instrument can

cause improper operation or serious damage. If you are unable to

retrieve a dropped screw, consult your Yamaha dealer for advice.

NReplace the hard disk cover, and attach with the four black

screws removed in step C. Install the backup batteries,

set the PSR-8000 right-side up, and connect the power

cord to the rear-panel AC INLET jack and an AC outlet.

MCheck that the installed hard disk is functioning properly.

Turn on the power, go to the DISK display, and execute the

FORMAT HARD DISK function. If the format is com-

pleted with no trouble, the hard disk is OK.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 205 206

No comments

Yamaha PSR8000 Owner's Manual Page 158