Yamaha MTX3 User Manual download pdf (Page 3)

1. Setup

1.1. Connection Procedure

Connection when using the NETWORK connector to perform remote control using this protocol

MTX3

MTX5-D

* Also for XMV, EXi8, and EXo8.

Connection when using the remote terminal to perform remote control using this protocol

MTX3

MTX5-D

* XMV, EXi8, and EXo8 do not have RS-232C connector

1.2. Configuring the Remote Controller

MTX3 and MTX5-D can be controlled from an external device through the Ethernet (NETWORK) terminal and remote (RS-232C) terminal.

XMV, EXi8, and EXo8 can be controlled from an external controller through the Ethernet (NETWORK) terminal.

The configuration on the remote controller side for each type of connection is shown below.

Ethernet (NETWORK connector) control

IP Address : S

ecif

the IP address of the device

ou want to control.

IP Port No. : 49280

Remote (RS-232C connector) control

RS232 port pin assignment

Bit Rate: The s

ecified bit rate.

Data: 8 bits

Parit

: none

Sto

bit: 1 bit

Flow Control : none

*Pin 4 and Pin 6 are connected internally.

*Pin 7 and Pin 8 are connected internally.

1.3. Device Configuration

1.3.1 MTX3 and MTX5-D

MTX3 and MTX5-D can be controlled via an external device through a NETWORK and RS-232C connector.

Two remote controllers can connect simultaneously via two available ports.

The first controller is fixed to using the NETWORK connector while the second controller can use the NETWORK or RS-232C connector.

The procedure to configure the second control port of MTX3 and MTX5-D is shown below, this is found in MTX Editor - System Menu- > Remote control.

(1) Select an MTX within the MTX system.

(2) Select NETWORK connector or RS-232C for Remote Control 2.

(3) Select 38400 or 115200 (if RS-232C is selected).

fter selecting all the parameters, click OK to complete the procedure.

* In the case of the MTX5-D NETWORK remote control connection, either network connector (Primary or Secondary) can be used when DANTE Daisy Chain mode is selected.

If using DANTE Redundant mode, only the Primary network connection and/or RS232 connection can be used for remote control.

1.3.2 XMV, EXi8, and EXo8

XMV, EXi8 and EXo8 can be controlled via an external device through a NETWORK connector.

Two remote controllers can connect simultaneously via two available ports.

As remote control of XMV, EXi8 and EXo8 is performed via the NETWORK connector only, there is no requirement to configure the port using MTX Editor.

When XMV

Exi8 and EXo8 are connected and controlled from MTX3 or MTX5-D

onl

one remote controller can be used

as one

ort is re

uired for s

stem control from MTX3 or MTX5-D.

Pin Name In/Out

GND5

4 Out

Out3

1NC

RxD

TxD

Out

Name In/Out

RTS

CTS

(1)

(2)

(3)

Remote Controller

Ethernet

Network

Switch

Remote Controller

Ethernet

Network

Switch

RS-232C (Cross cable)

Remote Controller

RS-232C (Cross cable)

Remote Controller

MTX3/MTX5-D/XMV Series/EXi8/EXo8 Remote Control Protocol Specifications V1.0.1

1 2 3 4 5 6 7 8 ... 44 45

Comments to this Manuals

No comments

Yamaha MTX3 User Manual Page 3

Comments to this Manuals

Related products and manuals for Processors Yamaha MTX3