search

Yamaha NX-N500 Owner's Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 309
  • Table of contents
  • TROUBLESHOOTING
    •
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 15
En 15
PREPARATIONS
English
■ Connecting to the network using a
cable
As a default, this unit will automatically make a network
connection when it is connected to a wired router and turned
on.
• When connecting to the network using a cable, a network connection will
be established regardless of whether the WIRELESS switch on the rear
panel is set to “AUTO” or “OFF”.
• If a wireless connection has already been established with this unit, the
WIRELESS switch on the unit must first be set to “OFF”. After turning off
the unit and connecting the network cable, set the WIRELESS switch to
“OFF”, and then turn the unit on again. In order to use Bluetooth, turn on
the unit before setting the WIRELESS switch to “AUTO”.
1
Make sure that this unit is connected to the
router with a cable.
2
Press z (power) on the remote control to turn
on the unit.
The network settings are automatically specified. While
the settings are being specified, the status indicator on
the front panel flashes in green.
When the connection is established, the status indicator
on the front panel changes to lit.
■ Sharing the iOS device setting
You can easily setup a wireless connection by applying the
connection settings on iOS devices (iPhone/iPod touch).
Before proceeding, confirm that your iOS device is connected
to a wireless router (access point).
• In order to share Wi-Fi settings, the iOS device must be installed with iOS
7 or later.
• Following the procedure below will reset specified account information
and registered preset settings.
• If network settings have already been specified, reset the network
connection, and then follow the procedure below.
• If a wired connection has already been established with this unit, the
WIRELESS switch on the unit must first be set to “OFF” while the unit is
on. After disconnecting the network cable, set the WIRELESS switch to
“AUTO”.
1
Set the WIRELESS switch on the rear panel to
“AUTO”.
2
Press z (power) on the remote control to turn
on the unit.
The status indicator on the front panel flashes in pink.
When this unit detects an iOS device, a connection
confirmation message appears.
3
Tap “Allow” in the iOS device screen.
When the connection is established, the status indicator
on the front panel lights up in green.
Green (flashing)
Left speaker (front panel)
Green (lit)
Left speaker (front panel)
R CH
AUDIO OUT
AUTO
OFF
WIRELESS
CONNECT
SOURCE
GAIN
AC IN
MAXMIN
WIRELESS
DIRECT
Left speaker (rear panel)
WIRELESS switch
Pink (flashing)
Left speaker (front panel)
Green (lit)
Left speaker (front panel)
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 308 309

Comments to this Manuals

No comments
Related products and manuals for Portable speakers Yamaha NX-N500
Portable speakers Yamaha NX-B55 Manual        (116 pages)
  • Kichler Lighting Luca Trazzi FibaTape Iron-curtain Husqvarna
  • Ativa Networking Davis Instruments Weather stations Behringer Audio cards Elkay Composite video cables Sony Motorcycle Accessories
  • Sony VCL-HG0862 Smeg A1CXU6 ProForm 310 Cx Bike Samsung HG40ED690UB Saeco HD8964/01
  • Flymo HT450 User Manual Midea WHD-125FW1 Owner's Manual Dell U2715H Monitor User Manual Yamaha GEP50 Owner's Manual Samsung PS51D8000FS User Manual