YSP-3000/YSP-30D/HTY-7030
20
YSP-3000/YSP-30D/
HTY-7030
9. プログラムの送信が終了すると、下記の画面が表示さ
れ、[OK]ボタンを押して完了します。(Fig. 6)
9. When the program transmission is completed, the screen
appears as shown below. (Fig. 6)
The press the [OK] button to end the procedure.
Fig. 6
VER. C_2.0817
10.本機の電源コードをACコンセントから抜きます。
11.“FlashSta.exe”を終了します。
12.RS232Cクロスケーブル、RS232C変換アダプターカー
ド電線を取り外します。
・ ファームウェアのバージョンおよびチェックサムの確認
ダイアグメニューでファームウェアが正しく更新された
ことを確認します。
ダイアグメニューの詳細は「自己診断(ダイアグ)」を参照
してください。
1. 本機の電源コードをACコンセントに接続します。
2.
本機の“VOL+”キーと“VOL-”キーを押しながら、リモコ
ンの“電源”キーを押し、ダイアグを起動します。
3. ダイアグ“19-1. Version”を選択します。
表示されたファームウェアのバージョンが書き込んだ
ファームウェアのバージョンと同じであることを確認し
ます。
10.Disconnect the power cable of main unit from the AC
outlet.
11.End “FlashSta. exe.”
12.Disconnect the RS232C cross cable, RS232C conver-
sion jig and flexible flat cable.
• Confirmation of firmware version and checksum
Confirm the firmware is updated successfully with the
self-diagnostic function.
For more information, refer to “SELF-DIAGNOSTIC
FUNCTION”.
1. Reconnect the power cable of main unit to the AC out-
let.
2. While pressing the “VOL+” key and “VOL-” key of the
main unit, press the “STANDBY/ON” key of the remote
control to activate the self-diagnostic function.
Then the self-diagnostic function is activated.
3. Select the self-diagnostic function menu “19-1. Ver-
sion”. Check the displayed firmware version is the
same as the written firmware version.
Key of main unit / 本体キー Key of remote control / リモコンキー
Press the “STANDBY/ON” key of the remote
control while pressing these keys.
これらのキーを同時に押しながら、リモコン
の“電源”キーを押します。
Comments to this Manuals